Rgreynolds
Member
Noticed the other day that at least half the screw holes on the wheel fairings are cracked. Short of buying new ones, anyone have any suggestions. I was thinking of using a clear epoxy and epoxying each one.
Wheel Fairings
- Thread starter Rgreynolds
- Start date
mlpeloquin
Well-known member
Some have used washers to give a larger area of support. So far only one screw hole on mine has cracked. Thinking of 3M structural epoxy with fiberglass mesh on the back side. Perhaps a washer on the front. Standard clear epoxies may not adhere well to the plastic even with sanding and proper degreasing. JB Weld may work, but it isn't clear. Also a lot of clear epoxies turn yellow over time.
