Not sure how the pre-wired setup works off of your tow vehicle or your house battery.. I installed my camera by tapping into the rigs running lights which are powered by my truck when the lights are on. I know that you could get voltage drop by the length of you conductors (wires) and the...
Not sure what type of system you have in the 2021. I have a 2013 Cyclone 3010 that has a hydraulic pump and two solenoids and I have had to manually operate them. One of the solenoids is for the slideouts and one for the landing gear. The pump and slideout solenoid are located near each other...
I had the same experience. It started over a year period. While on a recent road trip with a one night stop in Lubbock, TX my landing gear failed to come up after I pulled the slideouts in. I had to manually raise them. Stopped at an RV store and picked up a new battery and installed it at our...
This is not good. I have stink in mine as well. I’m planning on replacing my EPDM roof system soon and will check the vent pipes at that time. Thanks for sharing the pics of the problem!
I installed a Furrion system with a rear camera and two sides last April. Connected it to the 3010’s running lights. You need to check what wires are positive and negative as the two sides had all white wires. The rear had a green and a white. The trailer needs to be plugged in to the towing...
The upholstry is peeling on my sofa/couch which I am seeing is a common issue. I like the storage that we have with this setup and I am not looking to replace with something different. The plan is to re-upholster using Sunbrella material. My question is: Has any of you that has a Cyclone 3010 or...
I have a 2013 Cyclone 3010 that’s similar to the Warrior. A heads up on the switching valve operation if the operation was not explained to you. If you are on “City” do not rotate the valve switch to “Tank” or “Normal” while you have water pressure on the valve. Doing so may cause damage to the...
My kitchen gray tank valve (cable actuated) stopped closing completely while I was on a five week road trip. When I got home I dropped the coroplast (what a pain that is) and removed the valve. I spent a bit of time cleaning it with simple green and blowing air into it. A lot of sand/grit kept...
I recently watched a YouTube video that found the culprit of the smell you are describing. It can be found by doing a search for “WindersRanger” and “RV Tank Vent.” The guy discovered that the Heartland factory did not run the vent pipe up through the roof. Not saying that is your issue, but...
Thank you all for your wisdom and input! It was very helpful, and based on your input I have decided not to purchase the stabilizer and supports. Hope you has a wonderful Christmas and wishing you a Happy New Year!
Hi all!
i’m looking for advice/wisdom. I’m thinking of purchasing a king pin stabilizer and a pair of slideout supports. I have a few questions:
1) For those that are using or have used a king pin stabilizer, does it perform as intended, does it underperform, or is a king pin stabilizer...
Thank you to all of you for your responses!
I tried to duplicate the setup that that I had at Camp Richardson at home and have not had any leaks. As per most of your responses I’m attributing the leaks to high water pressure at the Camp Richardson site. And, per recommendation I’ll be looking...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.