We are having furnace issues and after reading several threads here, have not found the answer. The furnace in our 2011 Grand Canyon will only start if I take off the outside panel and flip the switch off, then on...it will then run until it reaches the set point. It will not run again until we go out and flip that switch...not nice to do at night when the grass is crispy.
We have tried lowering the temp on the controller until we hear a click in the A/C area, then turn it up again until we hear the click again. We have it set on auto for the fan. We have tried just pulling the fuse to get it to start, no luck there either.
Thoughts?
Marilyn
We have tried lowering the temp on the controller until we hear a click in the A/C area, then turn it up again until we hear the click again. We have it set on auto for the fan. We have tried just pulling the fuse to get it to start, no luck there either.
Thoughts?
Marilyn