PDA

View Full Version : Beaver tail Access?



RedFoxRacing
01-31-2014, 10:39 AM
We are noobs with a new 3110 Cyclone. I need to mount two Pit Bull trailer restraint systems in the garage of our rig. Problem is, the plates need to be 5 inches from the rear door and 5 inches from the side wall. I can access the plate from the panel above the floor but can not get to the extreme sides because there is metal under the floor. Pics would help, sorry. Any ideas on how to access from underside near where the walls would be? Thank you in advance.

danemayer
01-31-2014, 12:38 PM
Hi RedFoxRacing,

Congratulations on your new Cyclone and welcome to the Heartland Owners Forum. This is a great place to get answers to your questions and I expect another 3110 owner will chime in shortly with advice.

RedFoxRacing
02-02-2014, 03:32 PM
Never mind, finally had a warm day today. The left and right sides under the garage have a 1x8 foot strip of sheet metal that is held on with two screws and silicone seal. Was able to pry the sheet out and access the garage floor below the side walls. Two trailer restraint systems installed! No need for tie downs on the race bikes.

porthole
02-02-2014, 06:05 PM
Pictures - or it didn't happen!

Welcome and good luck with the trailer - lots of Cyclone folks here.

cavlino
03-08-2014, 08:09 PM
I have 2 Pit Bull plates in my Toy Hauler as well, they work great!