Quick Connect to Black Tank Flush..
OK.. I read on a forum about those using metal quick connects. They are expensive and will clog with the minerals that are in the water. Recommended that the use of the cheap plastic ones from Wally World is good and can be replaced easily.
So here'is what I do.
This is at the shore post. I use a Y and put my Regulator directly on it. Then use the Quick connects on both outlets. White connects to my 2 house Water filters I keep in a milk carton. Note the inline quick valve on the black hose..
This shows my 90* brass Quick connect that I never remove. I use the brass 90* because it fits close to the side of the box. I could not find one I liked that was 90*. Jim Belitti uses one that is a 120* (I think that is correct). It connects to the output from my House water filters. The plastic quick connect has a male nipple that I connect to my inline valve.
Now the in line quick connect valve is on and water is running to clean out the black tank. I can turn the water off here at the Distribution center when needed or when I am finished and want to remove it.
This is a closeup of the quick connect with a valve.
I also went to Lowe's and bought two Westinghouse house water filters, about $35 each, connected them with a coupler put water hose connectors on each end, connected my 3ft hose and added the brass 90* disconnect. The first filter is a good filter for large particles and the second is a charcoal to remove the taste of chlorine I then slide it under the trailer. It works well and is out of the way.
Hope this helps those that are intrested.