Recent content by adamo

Well, it's goodbye bumper and hello hitch. Ordered this one from etrailer http://www.etrailer.com/product.aspx?pc=13703&pg=Specialty-Trailer-Hitches&manuf=Curt&feed=npn&gclid=COGyqfvB3rwCFdeUfgod3hUACQ#prod-acc-onlyreviews It's a bolt on install but after I get it bolted in place I'm going to...

HAHA... nice OP!.. I have a Ford F-250 w/ 6.4L PSD and a similar story to yours except mine involved a Peterbuilt with a 53' Box trailer who had pulled of in some loose gravel off the side of the road in front of my house and dug himself in pretty good. I went outside to see what was going on...

Thanks again Jim, I just went down there today and spoke with Albert. They seemed very knowledgeable and I've got an appointment setup for next Monday to have a Class III receiver welded in with angle brackets and cross bracing plus wiring for $440.00 Funny I had never heard of them before...

Suppose you got a good point there Tombstonejim! I'm guessing by your handle you are from Tombstone. I'm just up the road from you in St. David. Small world huh?. That said is there anyone local you would recommend to do the job right? :)

Thanks for the responses. I've been reading all through the Big Country section of the site and the information I've come across is all pretty vague on what the frame will actually tolerate structurally other than to say that Lippert voids the warranty if you add a hitch. By the same note Ford...

Hi there, I recently picked up a Big Country 3940BHS 5th and am interested in towing my fishing boat behind it which is perfectly legal to do in my state. The boat with trailer together probably checks in between 2500-3000 lbs. I know some 5th wheels come equipped with a rear hitch for this...