Recent content by BKcyclone

So I did cut the liner open right after this last post. Oil, sawdust, water pipe scraps, and what ever else mess they made when building the camper. I found three hydraulic fittings that I don't believe were ever tightened. Based on the enormous amount of oil. So I tightened them and used...

I won't feel so bad then when I cut the thing open. y make it so hard....

Well great info, it is a 2021, sorry. My first thought was exactly to cut a whole and gorilla tape it back. I was hoping for a better idea. But great to know I'm not alone in that thought. I am afraid of the driven steel nail. I could not find a head of any kind the other day when I was...

So been a while, camper has been amazing. Multi point question. How do you remove the the under cover, that is part of the winter package. I have a small hole in it in the center ( i did not put there) where hydraulic oil is leaking. it has leaked quite a bit of oil over the winter. I see...

We have the king size bed that will sit you up if you hold down the switch, The switches located right in the crack or the bed hinges. The bed has to be to wear your back would be completely upright before the slide will come in so the bed will fit after the slide is in. All the way up I would...

So. I was Completely wrong on the motor. It was a bad safety switch to be sure the bed was all the upright before the room can come in.

So we have isolated the problem, I believe. We have power all they way to those wire nuts and they are secure. So I am thinking its a bad motor. don't know what else it could be.

We have 13.6 volts plugged in to 110v 15amp. In my shop now. Trying now to figure out if it's a circuit breaker??? Or does that even apply.....

Hello all, We have a 2021 Cyclone 4006, We are the second owners already. Our bedroom slide, (KIng Bed), won't come in at all. All you can hear is the solenoid clicking and no movement of the slide..... Can any one help???