Recent content by bobncab97

Bill, I didn't install any other batteries and I don't have any issues with the system operating normally. I do agree about the 200amps it took some time for me to wrap my head around it. Bob

Rick & Debbie I got everything which included the Jacks, mounts, hydraulic hoses, hydraulic pump with tank for the fluid which is all hooked up to the pump ready to be installed. Another nice thing about the type of fluid that goes in the the system is any type of Automatic Transmission Fluid...

Bill, I had to remove the Generator which wasn't that difficult just be sure to have help because it is around 150lbs and I used a very sturdy table to slide it onto while I did the work so there was very limited lifting required. No I didn't have to do any welding it was able to be put back...

Here is a few pictures of the broken screw jack and the Hydraulic System that I replaced it with.

No luck Jim at this time I will give it a try again tomorrow. Bob

Jimtoo, I am not able to post any pictures at this time because I am still new to the forum. I can how ever email them to you and you could post them for me. Later, Bob

Hello, I own a 2009 Heartland Cyclone 3950. The drivers side landing gear fell to the ground because the rod that holds the gear in place broke. I was able to chain the leg in the up position to get the coach home. After doing extensive research I found that HWH had the best sollution for...