Thanks for the replies. I decided to go with a small deep cell battery and charger instead of trying to get the #2 wires and circuit breaker in to the already jammed up battery boxes. I tested the winch with the battery and it works very well.
I want to run a #2 wire set from the batteries to the T31 garage through the underbelly to run the winch I want to use. How hard is it to drop the chloroplast and run cables in the underbelly? I have heard the driver side is less cluttered as the LP for the kitchen and water heater run down the...
Thanks for the replies. I didn't know that wireless HDMI existed and will look in to them for the short term answer to TV in the bedroom.
Ultimately I need to get a separate receiver in there so the wife can retire early and watch her shows while I play mine in the LR.
Thanks for the quick reply Dan. Right now I am using a DISH Playmaker which only supports a single receiver. I would have to move up to a DISH Tailgater which should support two receivers. I could always run direct to the second receiver through a window, but would prefer a cleaner installation.
The wiring diagram I just received from Heartland seems accurate. I have a coax in and satellite in near the left slide. The only satellite out is in the living room, along with a coax and booster. The bedroom, garage, and outside TV locations have a single coax that are all fed by the roof...
OK, it's been a few weeks since I posted. After getting the T-31 home and setting it up, my wife and I have come to love the sofas and folding table set up in the garage so I will not need the mod to make the floor flat. I should be able to get four dog crates in the remaining area, two side by...
EDIT: I just finished this project and will update in post #2.
I'm looking at the 5 X 8 Carry On Trailer at Lowes or Tractor Supply, with a removable tongue to carry along with my Honda Rancher ATV in the 12' garage of a T31. I need a trailer for the ATV once I get where I'm going. I'm pretty...
Ramp up. I want to support the crate rather than just have the end resting on the cleat. I found a video of a garage converted to an office. I may use their wedge idea and make three sections with lightweight Masonite, or very thin plywood, and 2 X 4 wedges just to support the full crate. We...
Good morning, first post, appreciate this forum. I will be moving up to a Torque T31 from a 27' TT and I'm looking for a way to fill the beavertail to make the floor flat once I am set up in camp. We train retrievers and travel with a bunch of them, so the garage will be the dog room once I pull...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.