Recent content by dmille3

How do you test or replace the brain

i installed my own bought a 4" hole saw from home depot i didn't go straight out i put it down toward to bottom used a metal hose with 2 90 degree turns it works great just don't get it to low so the outside door to cabinets will still latch open

Last month my heater didn't work I tried everything I new but couldn't get it to work, it would turn on run for a few minutes then turn off, had propane but put a full tank on anyway nothing worked had to call for service( almost killed me to do that) they came out and found a bad limit switch...

i use a bike rack that hooks onto the ladder frame it holds two bike and works good, i have used it for two years without problems got it at camping world

I bought a bike rack that fits over the ladder holds 2 bikes have used it for two years without any problems I do use a few extra straps bought it at camping world

for a temporary fix I used a 2 radiator clamps (sewer) and attached the motor to the post it works better than new but I will get a new one when I get home tomorrow thanks for all your help

Thanks for your help and advice. I did run the landing all the way up. I'm on my way home and will replace it when I get there.

The landing motor plastic house broke on my 2009 Big Horn. Can I fix it myself? Any suggestions?

Front Landing motor broke; plastic bracket. Can I fix it myself? Any suggestions?

make sure there is power to the element 110 than with power off disconnect white and black wire and check for continuity with omh meter if no continuity the element is bad, if no power check reset button and the circuit breaker when replacing element it doesn't matter witch wire white or black...

on the water heater it self there is as small electrical switch (usualy black)it has to be turned on i leave mine on all the time and use the red lighted switch to turn it on and off i always make sure the water heater is full of water before turning it on bleed all the air out of it

look on the wall in the cabinets if it back up to the shower walls some times there is an inspection plate there if there open and check for leaks and i usually only hand tighten them if loose do not over tighten

make sure it is high enough as not to interfere with the outside compartment door i put mine to low and the latch is not long enough but i put an extension on it and it works fine it was easy to drill used 4" whole saw from home depot

maybe by the tv boost the round silver looking think it takes an adapter for the tv mostly

I have a bh 3600rl and i installed the new splendide 2100xc it works great my wife loves it it will wash 15# not sure on the drying 12# i think the only problem i had is the opening is 1/2" or less too small and i had to remove the door and door jamb to fit it in once in place there is plenty...