We have two bathrooms in our Big Country and 1 of them has recently started shooting air bubbles out when flushing. I have flushed the system to make sure no excess gas has accumulated but still have the issue. Any thoughts?
I had done that previously and the only thing I can see in there is the hot and cold lines. Is there another location? Plus if there was a leak in there how would I fix it? The access point is very small.
Sent from my iPhone using Tapatalk
I'm having water seep through the floor and vanity and can't find the source. It's not coming from the sink and it does it during random times. I can't see where it would be coming from underneath. Does anyone else have this happen?
Sent from my iPhone using Tapatalk
Ok. Here's the update. Converter is good, battery is charged. The only thing I can think of that caused the initial problem was the slide got caught on something and it was draining the battery down because once it started opening I didn't have any more problems. Thanks for all your help...
Thank you for the comment and picture I will check the reset button. If I find that my converter is bad, how hard is it to get a new one and replace it?
Sent from my iPhone using Tapatalk
Thank you! After further investigation it appears my battery has run down. I have a 12 hour trickle charge going now to see if that remedies the problem.
Sent from my iPhone using Tapatalk
Are the slides strictly opened off of battery power? I noticed my batteries were extremely low. I always plug into the power source before letting the slides out but never had the problem I just had.
Sent from my iPhone using Tapatalk
Has anyone had trouble with their slide outs causing power surges when letting them out? We parked in Gainesville, FL today and when I was letting the slides out the A/C cut off and it sounded like there was an electrical short or something. Eventually they let out but that's the first time in...
There was some kind of grease build up in the hose so I poured hot water with a little bleach into the drip pan until I got a trickle outside, I then removed the black nozzle on the end and put some tie wire up the hose from the outside which removed the build up. It immediately started flowing...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.