Recent content by helmutforren

I didn't check the individual battery cells. However, the battery level indicator, with pump off, has remained at "G" for a while. I've used the tongue jack motor a few times while playing with a beam scale. I ran the slide out and in. I've run over 100 gallons through the pump while...

I was finally able to get everything done. So, at this point, ALL of the sensors on my KIB monitor are able to read at all levels. There are only two shortcomings: 1) It appears that the installer (Heartland factory) wired all power on a single wire, such that while the water pump is running...

@Hollandt, thanks sincerely for the unsolicited advice. I did already know those particular things, but had I not known I would have appreciated learning from you. Please keep it coming. @david-steph2018 et al., I made much better progress after actually filling the darned fresh water tank...

Thanks, @Dahillbilly and @david-steph2018. After midnight, I realized the error of my ways and subsequently found your consistent response, @david-steph2018. I further found this Water Systems Guide. Indeed, the Gravity Fill is on the opposite side from the City Water and not on a common...

I just purchased a used 2018 Heartland Pioneer RK280. As is from ************. None of the levels seem to work on the KIB monitor. I don't find a part number on the monitor, so here's a photo: As I press each of the 5 level selection buttons, the following happens REGARDLESS of conditions...