Recent content by Hippie

  1. H

    2006 Grand Canyon

    A stop at Ft Monroe Va. while on the way to Maine.
  2. H

    Replacing the carpet

    Has anyone replaced their carpet? We have the Berber a off-white carpet, it stains easily and the stain won't clean up.It is also wearing badly. We would like to replace it with vinyl flooring. Anyone have any suggestions?
  3. H

    Generator power distribution switch

    Thanks Jim. That's just what I was looking for. I'll cut a hole in the back of the extended frame on the truck and install it right beside socket where I plug the trailer brake and lights into.
  4. H

    Generator power distribution switch

    Thanks I never thought about the Marinco recepticle, and a manual transfer switch is what I was leanning to.
  5. H

    Generator power distribution switch

    I want to wire the genset from the truck to the trailer so I can put power on the trailer while we're driving. I want to leave the A/C units on and about an hour out from our stop I'll start the genset with a remote in the truck cab. This way we will have a cool trailer when we stop. I have a...
  6. H

    Generator power distribution switch

    Where did place the transfer switch?
  7. H

    Generator power distribution switch

    Thanks I'll call them.
  8. H

    Generator power distribution switch

    We have a 2006 Grand Canyon. It has the generator prep kit. I was wanting to know with the generator prep installed does it come with a power transfer switch? Thank you... Ralph...
  9. H

    Roof Mounted Satellite Systems

    We have the Winegard unit, and we love it. We got it two years ago. The only time we couldn't get a signal with it was when we were just south Augusta Me. We were out in the open but being at such high latitude we couldn't get over the tree line that was about a half mile away. We also carry a...
  10. H

    Furnace

    I have the thermostat wired ok, it's just where the wiring goes into the control module up in the ceiling just above the air filter. Thanks for your reply... Ralph D...
  11. H

    Furnace

    I got tired of the remote A/C module going out in the middle of the summer. It did it two years in a row. I replaced the control module with one that uses an analog thermostat. I have the A/C working ok, but I can’t get the furnace to work. The two blue wires coming from the board in the module...
  12. H

    Axle Bearing dust covers

    It wasn't the little plastic covers over the chrome hub covers. It was the dust caps that cover the bearings. When we pulled the bearings there wasn't to much grease, in fact they had what should be in there. The outer bearings were the ones that went out. We ran thru a rain storm and when we...
  13. H

    Axle Bearing dust covers

    Has anyone had their dust covers pop out? I had three pop out and roll around the chrome hub the covers the end of the axle. We went thru rain and the left front axle bearing went out. and the rear need to have the outer bearing to be replaced also. both axles bearings were on the left side. I...
Top