Recent content by jbhd

  1. J

    SOLVED: No DC Power (Sundance)

    Re: No DC Power (Sundance) So the issue was two fold: 1) The 50amp connection into the rig was not fully plugged in. Being a very heavy cable it came loose because it was not tighten down with the provided collar. 2) The batteries became discharged because the disconnect switch was on...
  2. J

    SOLVED: No DC Power (Sundance)

    Re: No DC Power (Sundance) Thanks for the replies. Found part of the problem. Some of the 110V are working. Microwave works, wall plugs works (the 2 I tested) the ceiling fan and light did not work and either did the the light over the dinning table. So I kind of knew right off as what...
  3. J

    SOLVED: No DC Power (Sundance)

    I went to my 2010 Sundance 3200re today to check it out (which is in an indoor storage) and none of the 12V systems work, landing gear, lights, nothing. Plugged in shore power and still nothing. The 120V is working as the Microwave clock is on a nightlight is on, the ceiling fan works but no...
  4. J

    Front landing legs not working

    Just an update on the landing gear: So I replaced the PITA fuse with a 30 AMP circuit breaker (type 1) auto reset. I blew the fuse again as I guess:confused: I retracted it to far. I stopped when I heard it clicked once. So, I'll not retract the LG's fully anymore. But if I do no more fuse...
  5. J

    Anyone else with a 2010 3200re

    Jim, I too figured it may be a thermal switch as it acts up when its in the sun. So I'll have RV American look at it. Thanks
  6. J

    Anyone else with a 2010 3200re

    So reporting back after our maiden voyage to Blue Mess at Gunnison, CO. around 280 miles from home. All-in-All the Sundance is an excellent 5er None. We had minor issues that I fixed at the camp site. #1 warranty work: As I was driving up I-70 about 80 miles into the trip my wife and I saw...
  7. J

    Front landing legs not working

    I use those yellow / orange RV leveling blocks. I had the SNAP Jack pins at hole 5 and I used 4 of the RV leveling blocks. I think it was the lay-of-the-Land. So for now :rolleyes:on I'll use 6 of the RV leveling blocks and have the Snap Jack pins at hole 6. John Boy
  8. J

    Winterization

    Dave, No that I'm in the RV on its maiden voyage I found the bypass values for the water heater. Now I'll go find the RV-Antifreeze siphon that westxsrt10 told me about. Thanks JB
  9. J

    Anyone else with a 2010 3200re

    Thanks westxsrt10... I'm sure I'll be able to find it now. Also now that I'm in the RV on it's maiden voyage I also see where the bypass values are for the water heater. Thanks again John Boy
  10. J

    Front landing legs not working

    Well on my maiden voyage I to blew the fuse. I read about this issue a week before I picked up the 3200RE. So here I am extending the legs to get it off the hitch. The motor started to labor a bit and I only needed a little more. Well I got a little bit more and at the same time the landing...
  11. J

    Winterization

    Thanks Dave that would be excellent. And thank you Ray for your information JB
  12. J

    Winterization

    So I have a new 2010 3200RE and I have not had the chance to investigate fully as to where are the Hot water bypass value and the RV-Antifreeze siphon. I looked at the diagram somewhat on the docking station. I posted this question under General discussion and received the following: so to...
  13. J

    Anyone else with a 2010 3200re

    brunsje, Where's then the TV? :eek::eek: No TV? Yes I bet the views with that large window is awsome!!:D
  14. J

    2010-3200RE Bedroom slide override

    Thanks Dave!!! Very much appericated
  15. J

    2010-3200RE Bedroom slide override

    Where is the Manual override for the Master bedroom slide on the 2010 3200RE? I went over the video I took during my PDI and the bedroom manual override was never brought up? I've read some post saying its under the bed:confused: or behind a board behind the bed.... I wish there were...
Top