Recent content by JMP

ditto

Re: It’s been a great ride! I believe we will all be back up and running in a month or so, maybe sooner. So, I got to believe HL is treating the current economic state as being in somewhat of a strategic pause.

I like the USMC emblem on the spare tire. Thank you for your service Master Guns.

Dmetcalf - wondering if you could provide a bit more detail on the term "Grade 8 hardware"? Thanks.

Totally awesome!

Yep. Just checked Michelin website. Ouch, I got 49k on my ltx ms2 235/80 r17E 117R truck now. Maybe the A/T will be next.

Nice video. Keeps it simple. Thanks.

Ditto

Most of you reading this post are probably going to laugh at me here, but i've got a recent story to share on my experience with the emergency breakaway switch - here it goes - as I was leaving Mayport Naval Station (Pelican Roost - waterfront site) this weekend. While moving forward and exiting...

Re: washer/dryer fit for front bedroom install Cyclone Jerapais - based off past experience collaborating with Pinnacle on repairs and warranty, i would not recommend anything pinnacle. On your other questions, I'm sure other's on the forum are better postured to offer you advice. Good luck.

Looks nice. Thanks for sharing your experience and fine workmanship.

These are the specs i use as well.

Am I looking at picture number #3 incorrectly? It looks like you have attached a brace across one set of your Lippert hydraulic struts.

Nice. Novel concept. I might try this approach. Does not seem to be difficult to measure out and install. Thanks for sharing.

I just shut-off the main breaker prior to disconnecting from shore power, and then after connecting to shore power turn on the main breaker. Are there other circuit breakers that [should] be turned off prior to disconnecting from shore power?