Recent content by justbob

Just installed one on a Ford 05 350 powerstroke. Haven't trailered with it yet but empty it sure will pull you down. I think I will like this set up. It took a little work to install, If not mechanical inclined I would let the dealer put it on. You have to install the Banks Econo tuner with it...

I opened up behinde the docking station and found that the fill line had a low place in it that allowed water to stay in, Tied this area up with cable ties so water will not stay in it and now it fills great.None I tried to push a smaller hose down but it would'nt go about 18" and it did help...

Are you saying to back feed the cable? What type of reading do we get? volt or ohms.

water fill A service man said the best and cheapest fix is to get 10' of white water hose, cut the male end off and run about 6' down the fill line while filling. Air can come back up around the fill line and excape. This saves taking down the belly and rerouting the vent. Store the hose in a...

On my BC 3250 TS there are 4 cable connections in the utilities compartment. I see there is one for front and one for the rear. The other 2 ? Any inf. is appreciated. thanks :confused:

range vent My 2009 3250 doesn't have one and the factory says they don't put vents in them. I'm going to try to find a way to put one in. Ther is a double wall in that area.

Thanks for the info. I think I'll forget it now don't want to ruin the 6 liter. I thank this forum for all the excellent information that is available.

Any body out there using water-methanol injection on there pullers. Looks like it's best to come on about 70% throttle. I'm pulling with a 2005 1 ton srw crew cab short bed Ford 6 liter with 3.73 gears.

S.W.owner Big Country owner in S.W. Mo. AuroraNone

Just took delivery of a 2009 Big Country 3250 TS. In looking at all, I don"t see any hot or cold water drains to drain the system. I have storage water drain, but no blue and red lines extending below. Do we just blow it out with compressed air or pump it out with pink anti-freeze? Any help is...

I took delivery of a new 2009 3250 Big Country last week. In going over it I can't find any low point drains for the hot and cold lines. I have fresh water drain. The book says to open drains, but can't find any. Do I try to blow them out with air pressure? Any help is appreciated. Thanks