Recent content by relic57

Hi All, Noticed on top of the front cap that the clear coat I think is peeling, sending a few pictures but am not sure. any one know if this is common and what does anyone think I can do to fix this. Thanks Dave

Noticed the faric on the roller is creeping to one side, which in turn has pulled the side bars to one side and will not shut. Any body have this happen and know how to correct this. Thanks Dave

Hi All, Did some cleaning of our egress window, and must have had it open to high, it came of the track on one side, and cannot get it back in. Any one have an idea how these go back in the track. Thanks Dave

Noticed this the other week. Ripples and bubbles above the bay door. They do not push in so I don't think it is de lamination, but could be wrong. Anyone have any idea about this. Thanks Dave

Had a guy look at it and it seems it was the two wires going to the lights for the switchs so we unplugged them, and the hot water tank fired up in propane mode. When we went to electric mode, the propane lit???? any ideas on why that happened. Thanks Dave

Already sent it back to Amazon, and ordered a board from Dinosaur, so we will see

off amazon

Yep, all good, wonder if i got a defective brand new board

Traced all the wires, and found when I took the wires off the circuit board, it did not trip the fuse. Got new circuit board ,now have lights on the switchs, but no ignition of gas and electric will not heat up water. Any ideas.

put new circuit board in, did not pop the fuse but now the igniter won't go on, and on electric it does not go on, any iteas. Dave

Have a 2017 Big Country, want to update the bedroom air, anybody done that. We have a whisper quiet system, anyone know what unit I may need.

Found out my circuit board went out and it was not a bad wire somewhere, that was popping my breakers. I have an Atwood, board number 91346. Heard it was discontinued, anybody know the new replacement number and where I might get one. Thanks Dave

checked the junction box and crawled way up into the bay to see all the wiring, could not find a thing going on. At a loss, have to have someone come check it out i guess. Dave

Have an Atwood, with 120 on ,still popped the fuse.

CHECKED ALL THE WIRING i COULD, DID NOT FIND ANYTHING LOOSE, BURNT ,BROKEN. TRIED THE SWITCH AGAIND WITH THE 120 VOLT BREAKER OFF AND THE FUSE TRIPPED AGAIN. i THINK IT IS IN THE 12 VOLT SOMEWHERE, BUT MIGHT HAVE TO HAVE SOMEONE COME IN TO TEST EVERYTHING.