Do you have the model number of this hitch and is it an Andersen hitch? This doesn't look any different than the aluminum model and I can't find it on the Andersen site.
So if your looking for a comparison then you need to compare apples to apples. If your looking for accident potential then compare all, and I mean all, hitches in exactly the same way. The only way your going to convince me that other hitches are better is to do the same exact loading test on...
"MorRyde HD shackles and wet bolts or the Dexter wet bolt kit"
I'm getting ready to install the correct alignment kit and have been wondering about the shackle selections. I've seen these two available but without specific knowledge of either of them I'm not sure which one would be a better...
I've been interested in a comparison between what my TST507 says for temperature and what the IR would show. I really don't travel like a lot of you do so does anyone happen to have some comparison numbers you could share showing the TPMS temp is or is not an accurate way to monitor tire...
I've been looking at other forums for SOB's and this is not just a Heartland issue. If you look at any other manufacture forums I'm betting you'll find the same complaints from other RV owners. I was window shopping a couple of weeks ago and found the same tires on just about every new trailer...
Electric Landing Gear Lubrication Tool After reading several post on how to disassemble landing gear to lubricate I looked through YouTube for awhile and ran accross this video. The first 2-3 minutes is muted but it will start shortly after the initial...
The previous post shows
Three height adjustments: 16-3/4" lower position, 17-7/8" middle position and 19-1/8" upper position (from bed of truck to top of ball mount). These are for the 3220
The 3221 numbers are:
Three height adjustments (measured from bed of truck to top of ball mount)...
Last year I had a discussion with TST about the internal sensors that use the band. They said they are switching to them because of issues with tire techs getting the stem mounted ones too tight and causing leaks or failures of the sensors. I didn't ask them however what the range of wheel...
I have a long bed (8') and use the Andersen ultimate with the pin release located behind the pin box. Don't need to crawl in the box for anything other than disconnecting chains. I also modified the chains to have hooks on both ends which allows easy removal for covered storage.
I'm not sure...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.