Recent content by RTSTRT

I had to remove the steps in our 2010 Sundance to replace my converter.

Well I found a SMALL crank that has a slotted end on it, its only 13" from the bend to the end. Problem is the crank does not stick out passed the basement door! Forget the slides it will not even reach the rod to crank out manually. It need to be at least another 12 to 14" longer to work

Had a situation this weekend, whereas we almost had to raise the front legs manually due to battery issue. Investing my options to raise them manually, I discovered that the manual pin on the side of the motor was not accessible due to the hole drilled from the factory was offset by about 4...

I like the product , did a Google search found them under $10.00 bucks but the shipping was more than the price of the item! May have to look around at our local RV stores.

We have a 2010 Sundance 3300SK and noticed toward the end of the camping season last fall, that the gray tanks were not fully emptying at the dump stations. We had inadvertantly left a gray tank valve open during the drive home and experienced a large amount of water being dumped from the unit...

Funny that you bring this issue up. I observed the same thing a couple of weeks ago after a trip home in the rain. After the 4th weekend had to drive home in the driving rain again. this weekend I removed all the bolts on the right side and the water just pored out from the "cardboard "...

Found the hold down pin & retaining cup for the spring at Redneck Trailers here in Wichita for $4.95. That sould get me back up and running agian. Thanks All

I was doing some maintenance on the wheels tonight and when I removed one of the hubs , the spring that holds the brake on was just floating around in there , the pin and the keeper were gone. I will try and find a brake shop and see if I can find the pin & keeper. The automotive stores I went...

I built the drawers the same width so i removed the glides and installed on the new box.

I had noticed that there was more room behind the drawers in the pantry , kitchen ,and bedroom areas, so I increased the size of those drawers. A few inches seemed to make a big differance in the space for each drawer. I used 1/2" birch plywood for the box and 1/4" birch on the bottoms.

We have just recently purchased a 2010 Sundance 3300SK and just returned from our intitial camping trip. We found a few things that we could fine tune to our liking and wanted to share them. First, the main light switch for the living room overheads was inside a cupboard door with the other main...

Our New 3300SK did the same, I put a big mark on the leg about an 1" before the stop point. That seemed to work .