Recent content by RyRoRyan

Not on a slide. Directly in the ceiling. Been working with Heartland Customer service, but they are having a hard time too. According to the guy I have been talking to, they don't keep wiring diagrams for their rigs! I was kinda shocked about this. He apparently has emailed someone who...

Been there already. No power in the ceiling but there is power to the switch and the switch does work. I traced the wire from the fuse panel to the switch and from there it goes back down into the basement into the wiring and plumbing area behind the basement storage area. From there I lose it...

I just emailed the below to heartland service, but since it is Sunday, I figured someone here may know already and I might get a quicker response here... Hello Heartland, I just got here to Silverton CO. to spend a week having fun on the trails. When I got here and tried to turn the overhead...

I will throw my 2 cents in here. I have a 2011 3800BH. It has been a great rig, minus a few small quality issues that I have noticed. I myself have seen this warping on the hitch area. What you will most likely find are small cracks in the caulking where the front cap connects the RV as well...

Hello, I was just wondering if someone on here knew or knew where to find the yearly production numbers for each model. I have a 2011 3800BH. I have never seen another one in existence. I know they exist, but just wanting to know how many of these do. Ryan

Yes, I am referring to what is apparently called the "filon." It is amazing how much information on these things they don't tell you about when you get them. I have the extended warranty for the paint and for the components of the coach. No one over told me to check the caulk every 6 months...

Hello all, I am hoping someone on here can give me some insight as to how to handle this. On the off-door side (which is really the side where the door is actually on...I have never understood this) where the bulkhead meets the front end cap, it has started to what I can only describe as...

No the gen has a L14-30 connector...4 in radius. Just ordered Camco 55422 which will make all this hookup the way I want it.

I have a Yamaha EF6300iSDE. It has a 30A per leg 4 wire twist lock but also has a 3 wire 30A twist. I have the adapter for the 3 wire but not the 4 wire twist to 4 wire blade. No it can't do the full 7200W but can do 52.5A max and 45.8A continuous. So instead of 3600W of possible power I can...

I should have been more clear. I see what you are saying. My generator is actually doing 240 30A via 2 phases (L1 and L2). It has the 4 wire connector just like 50A service does so it will send 120V down L1 and L2 just like the 50A pedestal does but just at 30A. All I was trying to figure...

Yes..I fully understand the 4 wire 2 phase setup, I have a 30A single phase connector so I can do that at pedestals as well. However my generator has both 30A 3wire and 30A 4 wire setups. i.e. 30A on L1 and 30A on L2 each with 120V then the neutral and ground. I should have clarified earlier...

My rig has is setup for 50 Amp service. My question is this...does anyone know if I plug it into a 50 Amp does it actually use both legs i.e. both phases of the 50 Amp or does it only use a single phase? I ask because I have an external yamaha generator that can do 120v 30A or also can do a...