Recent content by tdp100508

Re: Reviews We purchased a Landmark 365 Newport in July 2017. We now have had it for 6 months. We have had countless problems and am extremely disappointed with the build quality of our unit. In my opinion, it is a nice trailer that has been assembled with very poor workmanship. We are...

Thanks for sharing this. I will be the one doing the replacement installation and definitely will make as many improvements as I can. The L brackets from the factory are definitely not enough. There is way too much flex. I am surprised the factory has not improved on this. I have to say that the...

Good thought but no the tires are perfect. It happened while sitting in cold weather (0-10 degrees) I am thinking the screws were over tightened when installed and there was already a small crack. Then the cold made the metal contract cracking the plastic fender skirt much more. There is a lot...

I recently found that both fender skirts on my less than 6 month old Landmark 365 Newport have cracked. Has anyone else had this happen?

We also took delivery of a new Landmark 365 Newport in July of this year. I have been fixing things since day 1. We are full timing in ours so it is not convenient for us to bring it in for repairs. I do have to say that Heartland service has been good to work with so far and they have sent me...

I found three separate fuses like you show. One 10A, one 15A, one 20A. Pulled all three one at a time. Camera blue LED did not turn off with any of them.

I found that the trailer wiring was done incorrect in the junction box behind the pin box. The blue wire in the trailer cord was wired to the breakaway switch rather than to the actuator pump like it should have been. Rewired and now works like it should.

That may be my option. Thank you Rich

I installed a rear camera on my 2018 Landmark 365 Newport and it works fine. It has constant power. My question is, where does the wiring originate? I would like to install a switch to turn it off when not in use.

I have determined that the tow vehicle's integrated brake controller was on the incorrect setting. My fault for not reading the setup for the trailer brake settings. Being a newbie I am still learning.

Thank you for your input. I will check out the areas you mentioned. I may call Dexter for some assistance.

I have a new 2018 Landmark 365 Newport with disc brakes. When parked and no braking is being applied from the tow vehicle, the Dexter Electrically Controlled Hydraulic Brake Activation device make a surging sound. I sounds like it is trying to pump intermittently. The trailer brakes work fine...

Thank you Jim! This is a valuable site. I look forward to being a part of it. Thanks for getting my first post in the right spot too! Tim

Thanks Dan. I did contact customer service last week but have not received an answer yet. I will follow up with them. Best, Tim