Recent content by TianCi

That’sa great idea! I’ll see if they’ll do that! 👍🏻🤠

Not yet. However, I happen to be back where we bought the trailer (we live and travel full-time), and they are able to get me in next week. It may also be covered on our extended warranty. So, I decided to let them repair it! We'll see how it goes, and hopefully, they will teach me a few things...

The lower cable is not as loose as shown in your picture. The pulley assembly with the sheared screw heads is on the bottom right corner. The motor, chain, etc. are located on the bottom of the slide, behind the bed.

I have a 2014 Rushmore with the BAL Accu-slide on the bedroom slide. After finding two sheared off screws (heads), I discovered the right pulley assembly has two sheared screws (see image of assembly below). This installation is with the motor and adjustment cables on the bottom, behind the bed...

A hearty thank you to y'all who responded and quick update: Through extremely fortuitous circumstances as we are traveling and currently in Idaho, we were able to get our trailer into Smith RV in Idaho Falls, ID today. With my troubleshooting information and the information supplied by wdk450...

Thanks, danemayer, for the suggestion. My problem is that I can't figure out how to gain access to the wires between the switch (how to remove the switch) and where they exit near the lamp/thermistor harness. Does the whole refer have to be pulled and access is from the back of the unit...

I've looked through the forum trying to find a similar problem. If posted I did not find it. Our 2014 Landmark Rushmore has been relatively problem-free until yesterday. Opened the refer door and there was no light and noticed the unit was off. Downloaded the service manual and traced to a...

Sengli: I had thought about doing that, but just couldn't bring myself to penetrate the outer wall of my trailer. Thus, I opted for the backup plates.

I have read in several locations on this forum about basement door brackets pulling out of the door. This has now happened to me. Fixes suggested herein varied from Gorilla gluing the self-tapping screws back into the door, to installing a metal backing plate upon which the bracket can be...