Recent content by Touchngo

  1. T

    Fuse location for slideouts

    Loose wire at the motor connection above the slide. Got it connected tightly and the slide works now. - - - Updated - - - Thank you everyone for your help in tracking this down! It is greatly appreciated.
  2. T

    Fuse location for slideouts

    I do have a battery cutoff switch that can isolate one battery or the other or run them both together. I put that in myself since the trailer did not come with one. It is electric. Accu-slide cable system or something like that. Guess I'll have to try to trace down a loose wire.
  3. T

    Fuse location for slideouts

    I do not have an auto leveling system. I have a bank of two batteries. Power meter indicates full charge on each one and when cutoff switch is set to "both". Both of my other slides work fine. Landing gear works fine. (kitchen and bedroom closet). I disconnected power and ran a knife blade...
  4. T

    Fuse location for slideouts

    If any of them are manual reset, I was not able to feel any reset button on any of the breakers. I can certainly double check though.
  5. T

    Fuse location for slideouts

    Thanks. I am familiar with the relays. I just took the red covers off and did not notice that any had reset buttons, unless the tiny circle in the center of the relay between the positive and negative posts is a reset button.
  6. T

    Fuse location for slideouts

    I have a 2016 torque 321 toy hauler. The sofa slideout quit working yesterday about 2 seconds after I started to put it in. I went to check the fuse at the electrical panel, but the only slideout fuse that is located there is for the bedroom slide. I was wondering if anyone knows where the...
  7. T

    Torque 321 Bedroom Slide

    Me either. I'm certainly not small enough to fit between the ceiling and slide! Nor is my wife. Looks like the window is the only way to do it. Terrible design!
  8. T

    Torque 321 Bedroom Slide

    I just purchased a Torque 321 and have a question about the bedroom slide. It appears that the only way to manually operate the bedroom slide is from inside the bedroom. Problem is, there is no way to get into the bedroom if you needed to manually open it, and there is no way to get out of the...
  9. T

    And so it begins

    I do have a wheel chock. Not one that bolts down, but just a free-standing one. It hold my Harley Ultra upright, and being portable, I just store it under the trailer when not in use. I ordered 1" SS wood screws because I wasn't sure if the screws should go all the way through the wood or not...
  10. T

    And so it begins

    Looking to do this in a 2016 Torque 321 I just bought. With the L track all the way out on the edges, I don't have access underneath to bolt to anything. Middle is no problem accessing underneath. Wondering if your set up is the same and if you just used wood screws on the tracks, if you were...
Top