Recent content by Weshunt10

I did read through the whole thread including instruction 3 that says if your light is blinking these steps will not work. I did try the magnet before I found this thread though. Just hoping someone else has had the same variant of the problem as me and can offer some insight.

I have the L1op code with a blinking (once per second) red led on the limit switch. Research indicates that means low voltage. At my battery, I show 13.1 volts. At the control board I show 12.9 volts. When I disconnect the wire and plug it back up, the refrigerator kicks on for about 5 seconds...