Recent content by yondering

BTDT , used stainless screws and washers , also a dab of silicon in each washer hole . have a Blessed week , al & dee

we had this problem on our '09 Bighorn , one on the roller brackets had broken at the screw holes . dealer/heartland replaced the roller and sold us some nylon pads about 3' long and 6" wide . we lay them in front of the slide rollers before pulling in the slide . no more problems . have a...

Thanks JohnDar , your pics are a real Blessing , keeps me from having to take my cover down , measured beam from side to side and front to rear , used self tapping screws w/fender washers , puled up tight and removed sag , thanks again , have a very Blessed week , al weaver

Thanks for all the replys , I have not had any water run out , edges seem to be sealed , just a droop in the center . I am going to try some self tapping screws w/ fender washers and see what happens . will advise out come . have a Blessed weekend , al

mine seems to be sagging more towards the center . it is tight at the pin box and along the edges except on the curb side there is a few wrinkles . i noticed it because the cargo door handle hit the cover before the latch would engage . if i hear more , i will advise , thanks for the replys ...

the fiberglass cover between the front compartment and the hitch pin box below the front overhang ( confused yet ? ) is sagging . the latch for the compartment is screwed into this cover , and it seems to be solid . when i push up on it , it hits a solid backing , and no water ran out . question...

Thanks , i was wondering as the pics of each model looked the same . thanks again , Al

Can some one please explain the difference in the Hunter 42995 and 42999 digital thermostat . want to go digital on main ac/heat , but there are so many questions unanswered . thanks , Al

Very good forum !! I have a retired federal peace officers license , a Texas CHL , and yes , I do carry an HK USP 45 at all times , 13 rounds of federal hydra shock. I have not had any problems in any of the states we have traveled. If stopped , courtesy and having the CHL with your DL , makes...

Without getting too personal , would any of you guys give me a ballpark figure on the morryde IS , w/ disc brake and never lube setup. Thanks in advance , God Bless ya, Al Weaver

We spent the month of February at Quemado, Texas. We were on a mission trip to the Corner Stone Childrens Ranch. The Rio Grande river is about 100 yards from the ranch. Quemado is located just about half way between Eagle Pass , and Del Rio. We could hear gun fire not to far from us on the...

Good Job !!! The best way to get a message out is to keep it simple. Best wishes , God Bless ya , Al & Dee Weaver

Re: Winchester Bay Rallly Kristy , our HOC # is 1286 . C ya soon , God Bless ya , Al & Diana Weaver

Clymer , SOME of the noises are normal !!! I would check the suspension bolts and brackets , just to be sure that all is well. Too , check the bolts on the pin box for movement. Best wishes and may God Bless ya, Al & Dee Weaver

the tire ply rating is on the side wall of each tire. it may be listed as a alpha figure, such as E would be the ten ply I think, G is 12 ply and so on. anything less than a 10 ply on most rigs is not a good idea. of course, this is my little bit of info , I am sure you will hear more. God...