Search results

My generator has always been difficult to start on my 08 3210 and really has never ran properly. I finally discovered that there is a spring loaded check-ball in the outlet fitting on the gas tank where the generator fuel line attaches. This check-ball should open when the generator fuel pump...

I just wanted to let everyone know Heartland went FAR above what I'd expect to make everything right on my 3210. After I got off to a very rocky start the first few weeks with my 3210 and dealer, Heartland stepped-in and took care of everything. They let me take my 3210 to a "non-Heartland"...

Scott, I just noticed there is a 3/4 inch wide gap between two of the roof panels on my 3210. I guess I hadn't noticed it earlier because the rubber roof was stretched tightly enough that it covered the gap. The rubber roof has now started to sag approximately 1/2 inch deep into the gap, so...

Seems to me like the legs extend and retract very slowly -- much, much slower than any other 5th wheel I've owned. They haven't gotten any slower -- or faster -- since I brought the Cyclone home, so it may just be a characteristic of the system HL uses. Can anyone comment on what's "normal"...

Just something you might want to check on the line: When I arrived at the campground this weekend, I noticed a 1/2 inch gap between my water heater and the outside wall of the my 3210. I could easily move the water heater in and out approximately 1 inch. When I removed the water heater outer...

I've been pleasantly surprised by the maneuverability of the 3210. It tracks behind the truck during sharp turns much better than I would have expected. It is MUCH better than a 36' double-axle toyhauler I had. Although the 3210 is almost 34' long, it's maneuverability is pretty close to that of...

I noticed that there aren't any fasteners holding the front mount bracket to the floor. The rear bracket has 2 fasteners holding it to the floor (there are 4 holes in the bracket -- but only 2 screws). There are also several fasteners in the center part of the assembly that go into the floor...

I think it would be worthwhile for the factory to install something to keep the dinette drawers from opening on their own while traveling. Mine open every time I tow more than a few feet. It's a simple fix -- some drawer latches. We love the large u-shaped dinette -- it's one of the reasons...

In case anyone has a similar problem. The front roller on the bedroom slide came loose on my 3210 the second time I used the toyhauler. Since I don't have any confidence in my dealer, I decided to see if I could fix the roller myself. I discovered that the roller bracket is attached to a...

Scott, Does the factory glue the rubber matting to the plywood or is it held down by the side-walls and molding at the rear.

Thanks for all the info that folks have posted on the site! I've made myself a list of things to specifically look for on my PDI. Over the last 20 years, we've owned several different campers -- this will be our 3rd new toyhauler. We're really excited about the roomy layout, but relatively...