Search results

The fiberglass exterior skin of my 2009 Cyclone 3210 is waffling on the rear right side. There are five bulges in the center, at the rear seal. Could be moisture, heat, or stress. No damage to the interior. Anybody have a similar problem? Any ideas about what may actually be the problem?

I carry two motorcycles in my '09 3210, and don't use aftermarket wheel chocks. Instead, I made two chocks myself, using schedule 40 PVC pipe. They don't have to be bolted through the floor, and can be easily removed when hauling my Polaris ATV. I also have PVC bicycle racks. I could send...

Time to close out this thread with the end result. The water damage on the right side of my Cyclone 3210 was the result of penetration through the furnace flue. It became obvious when I removed the outside cover, and pulled up the floor. I had checked this possibility out when I first noticed...

Thanks for the reply. My rig was built in December, 2007, although it is a 2009 model. There is a plastic cup screwed into each corner of the opening for the slideout, with a rubber seal on it. The one where the leak is located was very wet inside when I took it off, the other appears to be...

There are two soft spots in the floor of my Cyclone 3210 from moisture damage. The first is located at the corner of the entrance door, right under the refrigerator. There are also water stains at the bottom of the entire refrigerator cabinet. Almost directly across, on the other side of the...

Your vehicle weight ratings are posted on the left inside doorpost of your truck, including weight ratings for each axle, the weight rating for the truck (GVWR), the weight rating for the truck and trailer (GCVWR), and the payload capacity. Toy haulers are a little different than other 5th...