Search results

I have a 2017 Bighorn 3870FB. After sitting at a campsite for the summer, when pulling in the slides to move I have an issue with the slide off door side. When pulling in the slide and also extending the rear portion acts like it has a gear issue and and jumps about every 5 inches to catch up...

2 Days Ago #1 mgarvin4 Junior MemberJoin DateJan 2013LocationUSA - OHPosts12 Current Rig 2013 Heartland Bighorn ATF: Bighorn - Stains around AC ventI have 3 duct vents that have moisture stains around them, 2 are AC output vents and 1 AC return air vent. All are in the back living area...

I have 3 duct vents that have moisture stains around them, 2 are AC output vents and 1 AC return air vent. All are in the back living area surrounding the ceiling fan. There was a TSB 98.01.19 that my dealer said was done. I never had any dripping of any kind or noticeable moisture around the...

I just purchased a 2017 Bighorn 3875FB with the Ivory walls and chocolate end caps. I am trying to find what brand and color sealer is used at the factory. I have not been able to find "ivory" sealer. Proflex has one they call almond but not sure if it is the same. I sent an email to a gentleman...

I was checking further and I think I have a bigger problem. The base of the bottom of the slide underneath the white covering seems to be deteriorating close to the outside wall where the indentions of the rollers set when the slide is closed. I had the unit at the Heartland facility a couple...

I've noticed on the underneath of my bedroom slide the covering is wrinkled/buckled that has also produced a crack in one of the wrinkles where the center roller is on the bottom. It doesn't appears the roller turns very well even after spraying some lubricant in it. Also there are indented...

To take the measurement from the bottom of the nose cap to the pin box I will have to take the cover off the pin box is that correct?

I have a 2013 Bighorn 3585RL. I recently noticed when I hookup and put the load on the hitch I have a small gap along the trim on the door side of the camper. It appears it flexs approx 1/8th inch. This summer I added a Splendid washer/dryer combo that sits on that side of the unit. Is this a...

Thanks Dan, that is what I am suspecting since I can feel the cylinder move back and forth when we push/pull the cable. I will try the backflush and also look at the Water Systems Guide.

I have a 2013 Bighorn 3585RL that is just past warranty. My problem is that I cannot drain my black tank. What can I do to check what the problem is? Iawas able to reach the valve by taking some of the screws out of the underbelly and I can feel the cable move when the valve is pulled but...

I haven't had much experiance with the Forum yet but what does it mean when it shows my post has been moved? Or has it been closed out? Where was it moved to?

I have a 3585RL Bighorn. I am not getting voltage to the solenoid that is on the manifold for the hydraulic slides. It is connected to a blue wire that is in a harness going through the front basement wall where the system is located. I had to use the bypass on the solenoid to retract my 2 main...

That is correct, the slide is not centered after it is extended. I have about 3/8" on one side and about 3/4" on the other. The outer seal doesn't quite touch on the one side of the slide but has full contact on the side towards the front of the camper. The dealer that made the adjustment on the...

I have a 2013 Bighorn 3585RL. My question involves the bedroom slide which is an Accuslide system. When the slide is extended out it appears the entire slide moves slightly forward and causes the outside seal flap to not lay against the slide. I have taken the unit to an authorized Heartland...