Search results

I have a 2017 Elkridge 30RLT 5th wheel, and I have two questions: 1. I turned the pump on for the fresh water pump at the control panel, tank has 1/2 tank of water, and pump will run (I can hear it running) but nothing comes out of the faucets. Is there a valve somewhere that is closed in...

I have a Haier 15 cu ft. residential frig in my 2017 Elkridge 30rlt. It seems to be too large for the opening. The front leveling feet "hang off" the platform and the freezer door hits the drawer pull on the island drawer, and it dented the freezer door. I had to put a spacer under the leveling...

I have a new Elkridge 5th wheel and the automatic leveler is sporatic on leveling. Is the "brains" module (about 5" square and 1" thick) located in the front compartment with the battery, on the roof of the compartment? I think mine is, and it is fastened to the roof with only one screw on one...

I just took delivery on my 2017 Elkridge 30rlt. This is our second RV, first being a Sundance bumper pull. It had the by-pass valves for winterizing the water heater. They are exposed under the pass-thru. I can not see any valves on the Elkridge. Does it have a by-pass system like the Sundance...

I just took delivery on my 2017 Elkridge 30RLT Tuesday, and I noticed a red light at one of the 15 amp fuse locations. I haven't had a chance to check it out fully. Does it just mean that fuse is blown?

My slide out leaks some when it rains. It gets on the floor inside, so, I checked all caulk around windows and trim outside and the only thing left is the seals for the slide out. The bottom is a ribbed 'D' seal with 5 ribs, and the sides and top are a short 'H' seal turned sideways, about...

The Sundance that I recently purchased has a cook top that I am going to replace. The hole in the counter is larger than any of the cook tops I have found. I have tried to find a commercially available spacer, but can't find one. What do we use as a spacer that will match the counter and not...

I recently bought a 2009 Sundance 280xlt and the cables for the slide out have too much slack. With the slide out "in" I can look on top at the end of the slide out and see the cables and motor. However, I can not figure out how to get too them. It looks like if I remove the "valence" on top...