Re: Dimond Plate
Sorry it took so long to say thanks for the info. Sounds good to me. I was still expecting a reply from the factory since this is the ask the facctory site. Once again thanks for you reply. Marty in Denver
I need to put some Diamond Plate on the front of my 21FBS, Could you send me a picture or blueprint of the front under the front cover. Have a "v" hole in on the bottom in the middle. Thanks Marty
Spent a 3 week streach in our 21Fbs and had no problem with food prep. Used both sinks and if we needed more room we used part of the table. There was just the wife and myself. When I cook I try to use as little room as possible. I make the mess, the wife cleans up. Marty
True the ficia is heldon by screws but it is also stapled to the top. once you get the screws out you need to pry the ficia away from the front. Its almost a two person job. One to pry and one to hold it up. Onice I got it off I cut the staples and the screws hold it up just fine. Marty in...
I asked this else where but I'll ask here also. Checking sink fittings to make sure everything was tight I found that there is nothing connected to my hot water connection of bathroom sink. Did someone fall down on the job or what? Marty
Moderator Note:
Longshot1, I'd say if you have a...
Hi Jonille. Have the installation guide right here. the oven is an Apollo and the cut out for the oven is 23 3/4 wide 16 5/8 high and 19 1/4 deep. They don't giv the inside demention on this paperwork. Hope this helps. And yess the battery does move the extention ..I was asking about...
Extertion
Thank you for doing that. I understand people ar busy but afterbeein in the partsand customer service aera for over 20 years I would think tat it should never take 3 days to call someone back. If he was out of town why did the operator transfer me to his number. I'm not really...
Extertion
Iwish I could get a quick reply. I called on Wed., Thur., and Fri., Operator connected me to someone. The recording said I am on the phome or away from my desk, I'll returnyour call as soon as i can. So far no call.
With the 5 screws out the fascia just hung there. After finding out about the nails I started pulling. Well if finally came off. The pin nails they used were two inches long. Some of them came out of the fascia and stayed in the backstop, others stayed in the fascia. So I just cut them off...
Well I took the 5 screws out of the top fascia on my 21FBS. but was unable to remove it. I don't want to pull to hard but it doesn't seem to move . Then I called the dealer and they told me I had to buy this adapter my self. I told them I don't think so. So hes checking to find a part...
Slide attchement
Thanks for the reply Jennifer. I just went out to the trailer. Took all the cushioons off of the dinette aera. took the 3 board out and all thats ther is about 4 or 5 inches of space. Nothing mechincal at all. I've asked the factory but with no luck yet. Thank for trying...
Well after reading about the slide attachment I put the slide out. There is nothing under the slide but a flat bottom and nothing above except a flat top. I have a 21FBS. I failed to ask at the PFI. This was only the second North Trail that the dealer had sold so they miss a few things...
I was told to ask Mike Creech if it is at all possible to get a diagram of the belly side of a North Trail 21FBS. With the sealed bottom its hard to know what is where. In case I have a problem. Second item (1st time) I see people talking about and adapter or sleeve to move the slide in...
Newbie
Got out 21FBS last month . Haven't had a chance to take it out yet. Too cold here in Colorado. Been getting it ready though. Had the heater on and it warmed it up real quick. Did you get any info on how to move the slide if there is no electric power avable? Did you get the...
After reading several messages on the forums here I find that several people has an extension of some kind to work the slide in there North Trail. Well I've got a slide but no extension what do I do? Also I didn't see anything about moving the slide in or out with out electric power in the...
I just purchased a North Trail 21fbs and was wondering if I could get a diagram of the underneath of the trailer. Something that shows where the water and drain lines go, also the wiring. Thank you Marty
I just picked up our 21FBS on Saturday. Had a Barker 3500 Power jack installed. Just went outside and looked at it. Looks like it uses the same holes as the manual crank up. Didn't see any other holes or any drilling to enlarge the holes on the tounge. Hoope this helps. Marty
We picked our 21FBs last Satursday. after spending and hour getting it in the side yard everything is great. When we picked it up it was dirty because of the snow so I spent some time cleaning the out side. Got a card for a free trailer detail because they didn't clean it. Have a safe trip...
Just bought a 21FBS trailer. Will pick it up in a couple of days. Read the booklet that comes with the trailer. It says that the slide can be move in manually if the battery or else fails, but doesn't say or show you how. So I'll ask how do yo do it? Thanks Marty
Will pick up out North Trails 2RBs on Thursday. Right now we have 2 trips planned To the NRAWhittington Center in Raton NM. Been going there every ear for the last 23 years. I'm Cheif Rande Officer for the BLACK POWDER CARTRIDGE RIFLE SILHOUETTE CHAMPIONSHIP, AND THE cOWBOY LEVER ACTION...
New North Trail owner
We we did it today, Bought a North Trails 21RBS. The dealer got it in Thursday and we will sign all the paperwork on Thursday a in 3 to 6 inches of snow I don't think will take it home then unless its not snowing. Wife loves the kitchen dinning aera. The dining slide...
Has Heartland made a place to store the black tank drain hose yet? Saw one on a dealers lot today and couldn't find any pkace for the hose. Marty
Marty was asking about a North Trail.
Does any one have one. We are thinking of geting one and was wondering what your opion of this trailer is.What do you think of the slide dining aera? Thanks Marty
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.