Search results

Best of luck! Sent from my iPhone using Tapatalk

Jim, my mistake it was Doug Chaney not Larry! asrtaylor - if you search for a thread entitled “Water manifold and Basement remodel( long and lots of photos)” you can see photos of hot water bypass valve in Doug Cheney’s posts #26, #40 & #48 of the 2013 Landmark Mesa. Hope this helps. Bob

Larry Chaney was the handy 1st owner, Jim. Hope to see you in Amarillo in May. Bob Sent from my iPhone using Tapatalk

Photos of 2013 Landmark Mesa. Original owner put in a water manifold but here are photos of the bypass. One photo is in front of UDC & the rest are behind it in the basement.

Had a flat tire on F-450 so will get photos today! [emoji3062] Sent from my iPad using Tapatalk

Will send photos Thursday Sent from my iPhone using Tapatalk

It’s on my to do list. Sent from my iPhone using Tapatalk

I assume you want photos from plumbing behind the water heater & UDC in the basement. If you need some other photos let me know. Bob Sent from my iPhone using Tapatalk

I have a 2012 Mesa here in AZ. I’ll stop by & take pictures tomorrow after Dr visit about 3 or 3:30 pm if that works for you Sent from my iPhone using Tapatalk

I have a 2013 Mesa built Feb 2012 here in Florence AZ. As Dan mentioned the information you are looking for isn’t in any manuals. If you are close by here I’d let you look at my RV Bob Sent from my iPhone using Tapatalk

Greetings Bill, next time you are down in Mesa give me a call so we can catch up! We bought a home here but need to escape the heat! Did you stay in Albuquerque? Sent from my iPhone using Tapatalk

Planning trip via Albuquerque, NM in July. Are campgrounds open and any road construction issues other than Amarillo? thanks

Glad you were safe & solved this problem. I too had a couple broken like you mentioned & replaced/repaired. However I never use it, instead I carry a little giant folding ladder to access roof. I use the RV ladder at top to keep little giant ladder from sliding of to the side. Sent from my...

Thanks Dan Sent from my iPhone using Tapatalk

My 2012 Landmark has a Perko “ on/off” dial (switch) in the door next to the buss bar above batteries. I have it in storage outside where I can safely run my 2 Honda generators ( EU2200 & EU 2200i with parallel cable) to plug into the 50 amp electric cord reel via a 50/30 amp plug. Does the...

Re: Quality? I bought Danemeyer’s steps 2 years ago & installed on my 2013 LM Mesa & were snug but we love them Sent from my iPhone using Tapatalk

This has been a whole week with temps in the AZ desert over 100 each day and the forecast for the next week is every day above 100 as well. I finally came up with a solution that allows the main AC to keep from tripping breaker. Both AC units are 15K. I created the RED NECK Desert Shade! I...

Checked all the items mentioned. The Eaton BD2015 breaker inside coach in panel trips after about 15 minutes. The progressive surge protector is showing voltage at 120+/- 5 & error code 0 if the breaker trips multiple time in this Arizona heat wave does that indicate the breaker is “weakened”...

Just like the old 4-H motto “learning by doing”! I also had to move one of the “D” ring tie downs. Sent from my iPhone using Tapatalk

Thanks to all who have installed their cargo tray and posted detailed information. Yesterday I installed my 29"x90" with Cargo Height Kit (CTG54-001). I encountered 2 issues 1) no instuctions on how to attach the Height Kit to bottom rail & got quick response from Ashley McClintic at MORryde...

Just called Lippert tech. Only thing that happens to touch panel (part # 421484) is what I’m experiencing! $270 plus shipping. I can still use this crippled touch pad till it comes. Turn on & hit up arrow 3 times then enter to get into manual mode. Wish we could be with you all at National...

Like I said it even though there are no words visible, the auto level worked. A bit baffling. I’ll check connections [emoji3166] Sent from my iPhone using Tapatalk

One does get spoiled with auto level! Just wondering where the words on the screen went[emoji3062] Sent from my iPhone using Tapatalk

Bad/Good surprise with screen on system. Turned on switch, green backlight came on, dots on the “baseball diamond” front, rear, left, right light up but no words visible! I hit auto-level & thank goodness it did just fine & then the success beep rang out. Any ideas on where my words on screen...

Advice needed to “ glue” fiberglass & eliminate gap on 2013 Landmark Mesa model. The front cap had a leak which allowed water to enter inside the front cap. The shoe rack on the inside front closet disintegrated. I sealed the seam on the roof using 3” Ethabond tape plus Dicor caulk. The...

The forum is amazing. I’ve spent the afternoon searching and found my answer! The bathroom sink & washer drain were combined then the former washer pipe was cut and capped. i found photos in post by SouthernNights 05-07-2012 with title “ Water manifold and basement remodel. (Long and lots of...

:rolleyes::rolleyes: Thanks for your insights. It’s always an adventure in the basement & beyond! 🧐

Agreed but I had some & thought it would give me some peace of mind! [emoji56] Sent from my iPhone using Tapatalk

Photo of tape over putty! Sent from my iPhone using Tapatalk

Thanks. Here is a photo after repair+plumber putty around outside of collar + waterproof Flex Tape for Insurance. Now to wait a bit to try it out! Bob Sent from my iPhone using Tapatalk

I noticed a small puddle in basement after being set up for a couple days. Found the flex hose was the problem as glue/cement failed. See photo of disconnect. Dried / applied cement & waiting to check seal. A question I have is what might the capped pipe in center be for? Do I have a 3 rd grey...

Thanks Dan I replaced the main buss bar breaker found in battery compartment & now will look for the other mentioned in the document. I really appreciate you assistance Bob Sent from my iPhone using Tapatalk

I’ve had similar issues. Often I don’t use “Auto Level” button on face plate . Instead I move the button down to manual & level the Landmark in that manner. ( not using the drill on pump) Can someone post a photo of the auto reset breaker & where to look for it? Thanks Bob Sent from my iPhone...

Does the Viair compressor have enough capacity to operate an air driven impact wrench? Sent from my iPad using Tapatalk

In my Landmark, I found the “brain” by sticking my head in the compartment where my Level-Up fluid reservoir is located & on frame above the metal box that surrounds the generator. A smaller thinner person would fit better than me & if that person was a contortionist it would make the task...

Jerrod those photos are impressive especially the multiple extensions on the drill. My 2013 Landmark has same set up but access door is much narrower. To adjust the cable yoke system on far side I have to take bed storage box floor out to access. What an engineering marvel this Norco System is...

Thanks, very helpful! Sent from my iPhone using Tapatalk

For those of us who purchased our Landmark from another owner, how & with who can we schedule work on our unit? The items I need addressed are probably more detailed that the 2 repairs we were able to schedule with the Heartland team on site. They did a great job but our Heartland “ TajMyHaul”...

I’ve run into refrigerator problems as well on a Norcold model 121X in my 2013 Landmark Mesa. Thanks to all the threads on the forum I’ve been trouble shooting with a couple items left to check/modify. Last summer at the Goshen rally I attended Terry Cooper’s 3 day academy & got educated, this...

Yes! Best time & $ well spent at Goshen Rally last year!!! Sent from my iPhone using Tapatalk