Search results

I sent you a PM.

I have a set that I took off of my Landmark that you can have. I live SE of Indy.

My shower hose is also difficult to remove at times. Make certain that no pressure remains in the hose, spray with WD 40 and work hose in and out at connector as explained above has always got it released.

I can feel your pain. Our LM San Antonio sits all summer connected to a utility that provides online access to our daily kwh usage. We have the large RV type refrigerator and operate it and the water heater on electric. When the trailer is non occupied with refrigerator and converter operating...

Ashland UDC Your receptacle should be GFCI protected and have a weatherproof cover. Switches do not offer GFCI protection unless provided at the breaker.

Re: Ashland UDC I doubt that it would be a 120V switch in the UDC. That would present a severe shock hazard.

Goof Off is also the product to use to remove the roadway lane marking paint sprayed up on your vehicle’s fenders if you are unfortunate enough to encounter roadway lane marking. It removes the paint without damaging the automotive finish. It also will work on your RV as well but you will need...

It looks like your new anode may be longer than old. It may be hitting back of tank. You can adjust with hacksaw if needed. Sent from my iPhone using Tapatalk

Take a 3/4” steel pipe coupling and try fitting it onto the new anode. That will tell you if you have an incorrectly threaded anode. Sent from my iPhone using Tapatalk

Etrailer carries several colors and widths. Be careful not to stretch the vinyl when you install it or it will shrink back. Sent from my iPhone using Tapatalk

I think we all realize that our trailers see frame flex as they are towed, turned, and cross uneven pavement. The fiberglass cracks at the corners of slide openings probably are cosmetic and would not represent a frame failure. The bulge in my estimation would indicate frame stress but not...

I have a 2015 LM San Antonio that was built early model year before the 365’s came out. I have the same curb side bulge as you indicate. I know there is frame structure behind the bulge because you can “read” the framework through the fiberglass when the dew is just right. The bulge is at the...

The bottom cord of that truss has definitely had a lateral shift at some point as all the rods in the same direction are broken. If the frame members appear to be straight I would grind/trim the ends of the rods until you can get them to align again. It appears difficult to get back to the top...

I see Demco also uses a clamp that fits against the pin box. This would be used in lieu of the capture plate. Sent from my iPad using Tapatalk

Unlike all other fifth wheel hitches, auto slide hitches are mechanically driven by the hitch head turning with the pin box. This is achieved by an adapter that is required to be used with the hitch. The adapter has a wedge that slides into the pin slot on the head to keep the pin from turning...

Sent from my iPad using Tapatalk

I assume you do have the locking adapter plate that installs on the pin box that locks the pin from turning in the hitch. It will have about a 1/2” thick steel wedge that sets behind the pin. Your comment about hitch head not being in the same position made me wonder. Sent from my iPad using...

I have the same hitch and tow a 2014 Landmark with the Moryde pin box. I find the hitch superior to my previous hitches with no noise or jerking during turns. Demco does recommend the top inspection plates be removed and grease be applied to the gearing. Perhaps the dry gear teeth are binding...