I replaced both pull-out steps with Morryde StepAbove steps and put in Morryde storage boxes in their place. I'll post pics of the completed areas once done, but I'm trying to find the plastic trim piece that goes around the step cut-out area.
Contacted CS and provided pics. Email back shows it shouldn't be an issue due to how the walls are made. At least I have the email in case something ever does. The stickers are put on at the factory. My guess is they did a design change and didn't update the sticker location guide.
Hello, I installed a dryer vent in my 2015 4200 exactly where the sticker showed, but found out that a support beam was almost dead center of the hole - pics attached. Is this something to be worried about? Thanks!
Hello, I just purchased a 2015 Cyclone 4200 and it looks like the previous owner removed the safety catch on the entry door and the wind must have caught it causing it to strike the vertical mount for the awning. It left a dent in the door and the paint/fiberglass is cracked - what can I use to...
Well....no pump yet. Now, they are looking for the rear sensor - not where they said it normally is - they are opening up the entire belly to find it. I'm still concerned about the whining of the pump when pulling in the sofa slide and that it didn't shut off when it was fully in. Can someone...
Hello - I'm wanting to add the support leg to the rear ramp - where does it go? If only one leg, I'm guessing in the center top edge - what about two? I've seen some Fusions with one on each side. Any pics would be appreciated. I'm also getting my patio deck/floor replaced due to water...
They are going to replace the pump - it sounded funny when pulling in the sofa slide - it whined at the end and never shut off. The PDI person said it didn't sound right. We'll see what the new pump does.
I'm at the dealer now trying to pick up a 2015 4200 that I'm buying - doing the same thing, but it's the right rear that only comes down a bit then stops - shows Level and done. Techs have replaced the control board, but still doing it. They said maybe the pump? I talked with previous owner and...
Those look like they will work! Thanks. I've seen some newer toy haulers with a camera on the back and one in the garage, but haven't found a Furrion model that shows the monitor which will show two cameras. Do you know if they are a different brand?
Hello - buying a used 2015 4200 HD - I don't see the camera prep area above the rear awning - is the wiring still there for anything? Would I just cautiously cut in that area to attach it? Thanks in advance!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.