Search results

Hey, I have a used, good condition ecobee smart si thermostat for sale. I also have a 4 channel relay board to go with it. I originally bought these to install in my 2011 big country, but I never got around to it. $100 obo, free shipping to boot.

Holding a plastic bag down to cover the vent till I find the right cover :D

I've bought two different 14x14 vent covers and neither of them fit this hinge. Can you ID a product that would, and uses that center bar system for opening it? Much appreciated

Oddly the brushes look fine on the old motor, plenty of length. There was a bit of dust.

Replaced the blower motor and all seems to be working well again. I don't think the original control board was the issue, but I must have shorted something out on it when I was testing things.

just learned that it could be the sail switch staying closed even when the blower stops. Then the sail switch doesn't open again until I smack it. Going to try replacing the sail switch.

Hey, I have a suburban SF-35 propane furnace in my 2011 Big Country. I’ve been having some sporadic issues with it turning on. A month ago it wouldn’t turn on unless I took the cover panel off and smacked it. So I took it out, cleaned out the intake and blower fan which had some dust but not a...

Hey all, I hopped up on my roof the other day for the first time in awhile and found some gaps in the caulking. I've gathered I need to use Dicor's self-leveling sealant to re-caulk the seams. I've also noticed the roof itself appears pretty worn, and leaves a chalky white on my hands/knees...

thanks for the quick response! Mine's definitely not working properly. I have a new one on order.

Hello, I am exploring a potential propane leak on the pigtail hoses (which might be why I've been going through so much propane lately). I have some questions regarding the ACR-2 dual regulator that came on my 2011 big country. Can the regulator be used with only one tank hooked up? I removed...

Gotcha, so definitely dont cover them with tape? :)

Can anyone tell me what these holes are for in the bottom of all the windows, and would they be contributing to drafts? Many ppl told me to expect lots of condensation inside the camper during winter, but I have had no condensation at all, which probably means there are lots of drafts keeping...

I do sawmilling full-time, so I have lots of firewood available to me. Anyone ever tried a small wood stove for heating? I was I could remove the glass out of one of the small rear side windows and use that to route a chimney pipe away from the camper, and then put the window back in when summer...

Hey all, I have a 2011 big country 3250ts and I noticed my slides are canted a little bit. The bottom of the two living room slides are about 1/2" to 1" further out than the top of the slides. I haven't had any water leaks. Is this intended?

Hey all, I've transitioned to full-time living in my 2011 Big country 3250TS. The biggest issue I'm having is that it's pretty cold in the RV, especially in the living room. I live outside of Asheville NC, so it's cold, but not northerly cold. I've been going through about one 30lb propane tank...

Got the ecobee powered up. Now comes the tougher part, I expect. It seems this Dometic system uses ground signals to activate the equipment, whereas the ecobee drives the signals to +12v. Anyone have experience with this? I supposed I can have the ecobee actuate relays... would like to reduce...

There's a mystery solved! I never really paid any attention to that fan roof hatch above the kitchen. The honeywell thermostat seemed to be doing something with a motor that opens/closes the hatch. Obviously since it's 30F outside I think it closed it. Found where the tstat wires run to, as...

Hey, I'm trying to swap in an Ecobee smart si thermostat on my 2011 big country. I got a little ahead of myself and didn't check the wiring behind my dometic thermostat before buying the smart si and getting all my tools out. Turns out the dometic has a 7.5vdc supply and the smart si needs...

I’m inspecting the underbelly off a used camper I bought, and I noticed the tanks bulge a bit. Is thugs cause for concern, or not really? Attached is a pic of my fresh water tank, 2/3 to 3/3 full.

I dialed the adjustment back a little bit and I’m happy with it Now. I ordered a replacement pump two weeks ago incase it needed a new pump. I can probably send that back. There was a connection behind the udc that had a small leak and I think was letting air in the line. Replaced that hose and...

Thank you! Should the pump cycle at all if I leave a faucet full open? I made a small adjustment. The pump runs for about 10 sec during full flow, turns off for about 3-4, runs for 10, repeat. (using the bathroom sink)

Hey there, I'm sure I can figure out which screw is the adjustment, but I did want to read whatever manual you were referencing. Page 3 of which manual?

Thanks for the quick reply. I'm going to give some of those docs a read! It would make sense if something was clogging the vent line, I'll give it a puff of air tomorrow. Here's a picture of the UDC: https://photos.app.goo.gl/viFijYGGSvTgRvJg7 valves are in the right position. Here's a video...

Hello, a couple months ago I bought a used BC 3250TS. Overall in good shape. I've got it set up on a property I'm starting to develop, and I'm transitioning to living in it full-time. I've noticed the water pressure tends to be "spurty". I thought when I got it it was just air in the line, but...