Search results

Hi Ken, I put an ignitor on our oven (we use it a lot). Went to a big box store and got one for a bbq and just followed directions. I could go on and on about installation and such but, it is not brain surgery. What is really nice is to find the 4 ignitor model and do the whole stove. Beats the...

Yes..

Don't sell your V-10 short. My F-250 V-10 SC LB with 4:30 rear is rated at 16200.

The "mushroom" houses of Charlevoix. The Pierce Stocking drive, Blackstar winery.

My 08 F-250 SC LB has a 38 gal. tank. The long bed tank is bigger.

On our 2900MK after less than 2 yrs I was having tire wear problems with the Towmax . I did a ton of research and chose the TransForce HT. Because of spacing I had to buy the 245-75-16. I was so pleased I transferred them to our new 12k rig and still going strong. The TV received new Dura vis...

We installed this film(from Lowes) on our Sundance. We couldn't sit in our recliners in the rear, now we can, it's that simple.

Jeez, now I find out Airstream is junk.....

We are planning on stopping to see you guys and spend the night on 4-08-13. Will that be OK?

Try going to audio menu and running the fader control back and forth.

HI, Rich and Bianca. Even though I am a SOB (Cedar Creek 34RLSA) we want to stop on the way back to MI and see you guys. I have a couple more years paid dues in the HOC. I hope you can still make a spot for us. We plan to be a bit early, Cynthia misses our home on L. Huron by April.

Check valves can be anywhere but backflow preventers must be 6 in. above the spill rim of the highest fixture. IIRC..

Thanks for the reminder Chuck. Yes we will stay over and leave on Mon. I will contact Hidden Ridge and confirm.

I just clamped a 2" receiver to my square tube bumper and away I went. MY welds seemed to be a little better than some I have seen. I also took the batteries out of the golf cart and put them in the truck. Very little tongue weight. I can tell you by looking in my rear view camera that there is...

cdbmidland, do you have room on your roster for Cynthia and Jim McNine? I made reservations with the park for 8-24 and 8-25. HOC #1297.

Had the spring break in the same place. Took the spring off and took it to a local spring place. They replaced the broken spring for 20 bucks. Might cost more if they had to take the spring off and replace it. At any rate it is not a big deal and all your springs are not shot. Catch a pot hole...

A/C's are not caulked usually. Take off the fascia on the inside and you will find a long bolt in each corner snug them up some. The A/C is clamped on a foam gasket.

I would recommend the Tucson area. Although, we try to limit the number of Montanans (rowdy bunch);)

Took that route a couple of years ago in Jan. from Green Valley to Canyon de Chelly. Temps were in the 60's. They don't usually get a lot of snow up there. I would keep an eye on the wx though.

I've changed that switch a couple of times. The easiest way is just pry it out with a screwdriver. The replacement switch is fairly common. The RV repair guy was working across the street, he had a bunch of them.

The outer part of the hub was hot but the center bearing part was not so much. Have a good feeling about that. I have an infra red thermometer why didn't I use it just for grins. That's the trouble with being a mechanical contractor I have so many tools I forget I have them. Now at my age I buy...

Update. Went back and forth in my driveway while applying the manual trailer brake control in order to adjust the brakes a little that I had loosened to make the drum easier to put on. Then took it out on the Hiway for a couple of miles applying the brakes often. When I returned the brakes were...

I've never been thrilled with my rv's brakes. So, I took advantage of Dexter's self adjusting brake special at the Gillette Rally. Spent the last two days installing same. (too hot in the afternoon) Found one unattached wire. No wonder my TBC kept going off and telling me I had a trailer wiring...

and McNines.

I used a bunch of sturdy S hooks from the bumpers to the trailer. (the route is littered with them)

I hauled my GC home from AZ. I started to lose one of the windshields so, I unscrewed the rest of the screws and put it inside. There is just too much travel in the suspension so, you have to tie down the axle part. I watched mine in the camera and there is a lot of movement back there. I used a...

Replaced my tow max with Firestone Transforce HT in 245 75 16. I needed the same diameter. The 235's are usually an inch bigger.

It's a date. Are you in the book?

I wondered what happened to you people. Fished out of there many times. Hope you don't have anything to do with the launch ramp. That place is a zoo. Did you stay at Elephant Butte?

If you are just spending the night the parking lot at Wall Drugs is fine and the fresh donuts in the morning are heavenly.

Getting prepped up for the Gillette Rally, greasing wet bolts, adjusting brakes, etc. Whoops, broken leaf on front doorside axle spring. I,ll call Lippert in the AM and order a new spring for about 60 bucks. Hope I can find time to put it on. Noticed in the yellow pages a little co. in a nearby...

Driving home from our winter place in Green Valley, AZ we had our GPS, rear view camera, TST and they were all unhappy until I put the rearview camera antenna on the back window. I think all that stuff operates on about the same freq. YMMV.

Oh by the way, got my elk in Raton, NM this Jan. 2012.

Cody, If you think we would like it sign us up, you're the boss. er ah wagonmaster.

Got your PM on chapter grouping. A lot of people like to do that. We have always preferred to take pot luck, met a lot of nice folks. Besides, how far away could you be?

Chris or do you prefer Razor. I just put a 5 STAR tune on my V-10 with the 4.30. You cannot believe the difference.

Received my 5 Star Tuner with 3 custom tunes yesterday. Ran it first without and then with the 87 octane performance tow tune. I am now another one of those V-10 owners with a permanent BSEG...

Used to be, look in NADA guides, no rig weighed over 9999#. I think it had to do with the 10,000# CDL thing.

IIRC the last couple of times I toured the factory they said because of new fed regs. the last thing as the trailer goes out the door it goes over the scale and gets its sticker. Correct me if I'm wrong.

I can't speak for Spartan tuners. But, ON the Ford truck site Everyone raves about Mike Butler at 5 Star. He is a Ford pro. They do SCT tuners. Call 843-250-0499. He will give you the straight info. My SCT X3 arrives tomorrow.