Thanks for the replies, we decided on Plan B, which is to pull out the undersized propane oven/stove unit and replace with halftime oven/stove unit that we had in our last North Trail. Then we plan to just remove the upper microwave and ugly hood, and replace with a nicer hood, slightly higher...
For our 2013 32 RLTS North Trail -
I'd like to replace our small, built in High Pointe microwave with an over the range, wall-mounted microwave/convection oven. This could allow me to get rid of the hood over the range that also gets in the way.
My question is can I use the slide-out wall to...
We have a 2010 North Trail 28RLS. Our slide is not the same as the one Silverado23 has. Ours has the electric motor on top of the slide over the kitchen sink. I checked outside by steps and also on slide side. No other manual crank attachments there. There is no frame extending outside, the...
Thanks to all who replied. I can see the motor on top of the slide, it's behind the upper facia, right over the sink. It makes sense that the hex tool that was supplied goes into the motor, I just am not looking forward to removing the facia. I tried unscrewing all the visible screws, but the...
We have a 2010 North Trail RLS. Slide motor is in the middle at the top, but we can not figure out how to move it manually. We have a hex drive on a flexible extension, but there is no obvious panel to remove or other way to access the motor.
Can someone PLEASE advise how to do this?
Want to mount a ladder on back of our 28RLS North Trail. Would like to minimize obstructing view from the back window if possible. Does Heartland sell these ladders? Can I get dimensions to install this myself?
We have a 28RLS North Trail (bought Aug 2009). Need to install a bar on the outside to mount a gas grill. Can someone provide dimensions to drill the holes to mount the bar?
Want to mount a ladder on back of our 28RLS North Trail. Would like to minimize obstructing view from the back window if possible. Does Heartland sell these ladders? Can I get dimensions to install this myself?
We have a 28RLS North Trail (bought Aug 2009). Need to install a bar on the outside to mount a gas grill. Can someone provide dimensions to drill the holes to mount the bar?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.