PSA- I just got it, so can't attest to durability, but I bought the Classic Accessories PolyPro 3 Rpod 20' trailer cover (designed for Rpod 179 series) and it fits my mpg183 like a glove.
Does anyone know of a tonneau cover that will work with a low-profile toolbox. The toolbox height is slightly lower than the top of the bedrails. There is about 1-1/2" of clearance on either side of the tool box (between the lid and bed rails). I'm concerned that the tonneau cover hardware...
Does anyone know how much weight the roof of a 3150 wilderness travel trailer will support? Need to put vent covers on and would be easier to put on RV cover if I can walk on roof.
Does anyone out there know if there is a cover available yet for the Heartland MPG series of trailers? Since I will be picking my new 181 up this coming Tuesday afternoon, that thought has popped into my mind, especially since I will be storing my trailer in an RV storage facility (outside). I...
The monitors for gray 1, gray 2 and holding tank do not read empty no matter how long I leave the drain valves open. The dealer told me to remove the faceplate, disconnect the leads and reconnect them to see if there is a problem there.
How do I remove the faceplate on my 3055 without...
Looking at the hitch cover I saw two ways to convert the hitch cover to work in a 2½” receiver.
1) Cut off current raised mounting tabs and then drill holes where the tabs were located. Then put in bolts with washers or spacers to bring the top of the bolt even with the outside of the receiver...
Thinking about an RV cover, been leaning towards Goldline Cover, anyone have any experience with this cover?,..good or bad..
Thanks,
Fred
RIP
R.C.B. (Woolly Bugger)
I am considering buying a 5th Wheel cover and these options look good. The first two are about the same cost and the last is half the cost:
- Coverking, which uses a 600 denier woven polyester (http://www.coverkingcarcovers.com/Coverking-RV-Covers.html)
- National Discount Covers Goldine...
It's been wet here in the Portland area for awhile and the forecast is for continued wet. I am getting ready to do the winterization thing for the first time and was wondering about putting a cover on the A/C unit. What are the pros and cons? Do I need to wait for a spell of dry weather or...
Already did a search ........
I'd like to buy one cover and spend the money once for a good cover.
Living in the Northeast, so something that will stand up to harsh winter.
Ideally I am looking for ht best one made - brand etc.
This will be for our Cyclone, which is 36' long, excluding...
Hey guys bought my 09 3612 last summer and I need to cover it up. Does anyone have any pro's / con's or experience with a particular cover. I have had it waxed and keep it clean but I want it out of the sun. My trim around the windows had turned a little so has the vent a hood vent which is...
I have an ADCO 5th Wheel cover originally bought for my Montana 2955RL. Used only for a few months before the rig was totalled and replaced with my Heartland Bighorn 3055, two feet too big.
I'm in Central CA but moving to the PNW and would like to sell instead of moving it.
We are leaving our trailer at the camp site all winter in northern Wisconsin. The campground host says most yearly campers leave trailers uncovered and don't have any problems. A friend at home always uses a tarp and prefers that. Some say cover for birds, weather, etc. Others say they have...
Wouldn't it be nice to have available a fitted sink cover to expand the counter space? (Matching the counter, of course.) The kitchen sink in the Edge seems to have the perfect indent around the perimeter for something to fit quite nicely - could even double as a cutting board on the flip side!
I have been blessed by the midwest thunderstorms and hail (3 times). The only damage suffered each time was the manual roof vent covers. The fantastic fan vent cover, a/c covers and satilite dish have never been touched by the hail. I have replaced the originals with dark shaded the first time...
We just bought a Landmark Grand Canyon and it will be parked in Yuma Az
year round. I am looking for comments regarding the purchase of a good cover. I would like to protect it from the intense heat in the summer.
As there is little moisture I don't think there will be mold concerns and I am...
I could use some more advice. Your advice so far has been VERY helpful. This time I need it on hitches and bed covers.
Relevant background information: We’re looking at getting an Augusta for full-time use and will be pulling it with a 2010 Dodge 3500 crew cab, long-bed dully and will get a...
I have a 2007 Dodge 2500HD Quad cab with short box.
Has anybody run into a soft or folding tonneau cover that
works well with a fifth wheel hitch and a below cab tool box.
We are volunteers in state and/or National parks and usually
stay in one spot for 2 or 3 months. I remove the fifth wheel...
We have a new Bighorn 3055 and we have a problem. Both the thermostat and fantastic fan controls are in the "hallway" over the steps in to the bathroom/bedroom area.
It seems that we continually hit those controls when we carry something into or out of the bathroom/bedroom.
We would like to...
Anyone have any idea where I could find a retractable skylight cover for the skylight in the shower? The skylight lets in too much light in the sleeping area in the mornings.
:confused:Should the Magic Chef oven/stove in our 08 Sundance 3300sk have come with a range cover that goes over the top burners? Everyone that has been inside beleives it should have one.
Thanks: JWNone
I wanted to share a picture of our cover for our Bighorn 3400 RL. This is 18' X 41' so you can extend the slides. The unit was about $2,900 delivered and setup. In our county this is considered a temporary structure so no permit was required. If any member wants more information, send me a...
I am a new RVer and when we purchased this spring, I bought a cover for storage. We purchased a Sundance 2900MK, 5th wheel.
Is putting one of these covers on pretty easy? Any tips from experienced RVers? Besides building a pole barn! LOL
Hello All,
I have a question that may sound stupid. I know that the refrigerator needs to be vented while working on gas but am wondering about when running on electric. I put my cover on last week for the winter but still have access to power. With Thanksgiving coming up the extra refridgerator...
Has anyone had the cover break off covering their outside co ax? It just has the plastic for a hinge and broke after only using it about 5 times. If anyone has had this break what was your fix?
I was wondering if anyone can point me in the right direction for a good reasonably priced cover for our Razor? We have the 3212SB and want to keep it looking sharp.:)
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.