Ray LeTourneau; I used a 5 inch diameter computer coolong fan and it runs on 12 volts and has an on/off switch.[/QUOTE said:Ray:
Where do you get your 12 volt power from for the fan? Where does the cooler air come from.
My 3400 has a 12 volt outlet in the entertainment area. I don't know why but I think they did away with those outlets in 2009. You can pick up 12 volts from any nearby light though. The fan is designed to pull the warm air out so the cooer air comes i from the living area. I mounted the fan to the inner surface of the side wall in the TV compartment and operate it manually as needed. On the outside of the wall I have a residential dryer vent but would like to replace that with one of those chrome RV dryer vents soon. I haven't taken any pictures yet and have to work the next couple days but I'll get some posted asap.Where do you get your 12 volt power from for the fan? Where does the cooler air come from.
Service has supplied to me, the Coax Layout for the current Cyclone and Road Warrior products. It is more a wiring diagram than it is a wire routing document. I have placed it in HOM (Heartland Owners Manuals). Here's a link.
The layout is very helpful. thanks, would you be able to find out what cable connect to the TV Booster in the bedroom. I am sure that one of them is the TV antenna but of the other two which one connects to the booster and which connects to the botton connector?
Service has supplied to me, the Coax Layout for the current Cyclone and Road Warrior products. It is more a wiring diagram than it is a wire routing document. I have placed it in HOM (Heartland Owners Manuals). Here's a link.
Following the drawing, here's what the cables are "on the back" of the wall-plate:
Cable TV Input
TV Antenna Input
Output 1
On the front of the wall-plate, there is one jack. Call this
Output 2
The way it works is:
With the switch on the wall-plate OFF (no red light):
- The Cable TV input is selected and that signal is routed to Output 1 & 2
With the switch on the wall-plate ON (red light is illuminated):
- The TV Antenna input is selected and that signal is routed to Output 1 & 2
Does this help? Please reply with more specific questions, now that you know what the cables are.
Jim