We installed a second TV in the bedroom of our 3400. Before we did, the main TV in the living area worked fine with the antenna (with the booster on of course). Now, when we connect the bedroom TV to the coax connector, the main TV looses most of the signal. I even disconnected the A/B switch and ran direct to the living room TV.
We also had cable available at the park we were at, so I connected that in the docking station. The bedroom TV worked great after I turned off the antenna booster, but nothing on the TV in the livingroom. I am not sure where to go from here, I even studied the wiring diagram that Jim B. has posted. I was going to open up the coax plate in the bedroom to see what was behind it, and how the signal gets to the living area. Then, I thought I would short the cables one at a time to try and figure out with my ohm meter where they run. Any other ideas or advise?
We also had cable available at the park we were at, so I connected that in the docking station. The bedroom TV worked great after I turned off the antenna booster, but nothing on the TV in the livingroom. I am not sure where to go from here, I even studied the wiring diagram that Jim B. has posted. I was going to open up the coax plate in the bedroom to see what was behind it, and how the signal gets to the living area. Then, I thought I would short the cables one at a time to try and figure out with my ohm meter where they run. Any other ideas or advise?