lduguay
Past North Carolina Chapter Leader
We pick up our BC 3250TS next week in Michigan, weather permitting. The P3 was installed about 2 weeks ago. It has rained 2 times since the install and both x's the P3 flashed RED, "BRAKE SHORT NO BRAKES".......the installer said it shouldn't do that once we are hooked up.
I am NOT comfortable with that answer....especially towing home via the Smokey Mtn range!!!
I did a visual check and wiring at splice point under bed (had plug installed inside P/U bed) all "look" good, I then wrapped the spiced area with plastic and sealed with electrical tape to at least partially waterproof the splices. Well, I ran the truck through a local car wash and the warning light came on again, "BRAKE SHORT, NO BRAKES".
Oh, warning light goes off after "things" dry up??
I am taking it back to the installer but wondering if "yall" have suggestions. Thanks!
I am NOT comfortable with that answer....especially towing home via the Smokey Mtn range!!!
I did a visual check and wiring at splice point under bed (had plug installed inside P/U bed) all "look" good, I then wrapped the spiced area with plastic and sealed with electrical tape to at least partially waterproof the splices. Well, I ran the truck through a local car wash and the warning light came on again, "BRAKE SHORT, NO BRAKES".
Oh, warning light goes off after "things" dry up??
I am taking it back to the installer but wondering if "yall" have suggestions. Thanks!