jmaguire
Well-known member
I am working on a project to make a mobile solar power station for our RV's. I am going to size the load to run all the 12v. loads in the RV, and charge a dual battery setup during the day to power the loads at night. I need the following information to complete the load analysis.
1. The wattage of the reefer while using lp gas.
2. The wattage of the water heater using lp gas.
3. The wattage of the water pump.
4. Approximate lighting wattages.
5. Any incidental wattages like CO detectors ect.
This will go into my calculations for panels and inverter/controller. Hopefully I will be making a solar panel setup that can be stored in the RV, and then setup when the RV is setup. You should always try and face your panels south, and angle them close to your latitude angle.
1. The wattage of the reefer while using lp gas.
2. The wattage of the water heater using lp gas.
3. The wattage of the water pump.
4. Approximate lighting wattages.
5. Any incidental wattages like CO detectors ect.
This will go into my calculations for panels and inverter/controller. Hopefully I will be making a solar panel setup that can be stored in the RV, and then setup when the RV is setup. You should always try and face your panels south, and angle them close to your latitude angle.