View Full Version : Quick connector

El Santiago
10-13-2007, 06:57 AM
The spray port in the docking center is equiped with a female quick connector so that I can insert the male part of the coiled hose when cleaning the black tank after flushing. Until last week, I never had a problem connecting the hose to the spray port. Yesterday, when I went to clean the black tank, I was not able to connect the coiled hose to the spray port. Of course, I pulled the band on the female connector to facilitate the insertion but no luck. What am I doing wrong?

10-13-2007, 07:07 AM
Here is the trouble shooting page from DWI. Obviously you made sure your taps were shut but maybe try #2 and 3 on the page. Some one else had the same problem and it worked or them. Good luck.


El Santiago
10-13-2007, 07:15 AM
Thank you very much Nhunter. That should do it.

10-13-2007, 07:44 AM
I had to give mine a tap on the little valve in the middle with a small screwdriver.

10-13-2007, 08:01 AM
A few months back, I sort of grilled the folks at DWI about how hard the spray port quick coupling can be to insert. They told me that over time, the brass oxidizes and that build-up of oxidation is what makes it harder to plug the connector in. Tip 3 on their help page was what they told me to do. I never tried it but it sounds viable.

Personally, I'd still like to try this:

Then use a brass on/off valve and a coiled hose with a standard male hose connector on it.


10-13-2007, 09:10 AM
I better give Jim the credit for finding that page in the first place. I just saved it from his link.

10-13-2007, 09:36 AM

You are too kind but no credit to me is due or needed. I'd like to think I'm fairly humble.

But since you we're giving out credits, it was yet another forum member that turned me onto DWI. Not sure who it was but it was like a mini-goldmine find I thought.