Recent content by 360gal

Heading up from Spokane to Banff and Lake Louise. Does anyone have any suggestions for RV parks that can accommodate a Landmark Rushmore? This is a last minute trip/adventure. hope all that I know in the club are doing well Diana 360gal

As always, can count on my rv guys to help out..thanks jim and brian

Just took the rv ou and I have 3 foggy windows...the entire back picture window, and two sides. Why all of a sudden? Driest winter on record.... where should i go I go to get them repaired/replaced, and can I change them out to the flat frameless windows? hi to all that I've not seen in...

A heartfelt thank you to Heartland, john and Lori, and the Belettis. Jim, your enthusiasm is contagious! Had a wonderful time at the rally (minus the oppressive heat). The dinner, show and buffet were all top notch. My "partner" thanks you as well. John, it took 3 days to get home on another...

My goodness, thank you for all the replies. The sleep number I tried out at camping world felt like an air mattress. My home mattress weighs well over a hundred pounds, plus it doesn't come in rv size. I've done a little research and Denver mattresses are sold at a dealership on the other side...

The mattress that came with my landmark has finally reached the end of its life...I was able to get 4 years out of it.... does anybody have have any thoughts on buying new mattress. Camping world had sleep number and some other cheap mattress. Jim Beletti mentioned Denver mattress company...

Each time I go to storage to pick up rv, bedroom slide is out 8-10". I've called my service dept, and they stated it could be hydraulic jack fluid. Sometimes debris and water can get in and cause this. He said for me to drain it and put in new fluid, which he said I could do, OR for 250 they...

Looking forward to seeing everyone. Does anyone have the best route from Oregon to Sparks? Count 2 for me....and Sadie too!

John, thank you for the laugh...

Al and donna, and all who replied to this thread. I think Indiana is too far, even for me :cool:. If there were others leaving from here, here being Oregon, I might have considered caravaning. As to being confronted by jealous wives...haven't encountered any of that. People have been so...

My goodness, lots of responses, even from a superhero type, lol! I so appreciate all your advice. It does look a bit corroded, so the tape sounds like a good idea. That I know how to do. Will be careful not to get in tank. Ive enlisted the help of someone with bigger muscles, bigger tools, and...

You would be correct, I don't even think its 12"...back to the napa store!

Thank you Dave...I did purchase an adapter for the socket, from 3/8 to 1/2, however the wrench part(if that's what it's called), isn't 1/2". I'm assuming the whole thing should be 1/2" rather than using the adapter. Is this correct?

What is a half inch drive tool?

Oh and is this where I look for a husband to do this for me....LOL!!!