Recent content by bggrndodge

Thanks for all the input, its a big job, and I want it done right the first time. It took CW almost a year to get my decal replaced under warranty with multiple trips back because they didn't order the right one, or forgot one or whatever. Not impressed and that was a job that I would think...

I need to find a place to repair my rubber roof near Sacramento, and not camping world in Roseville due to a bad warranty experience. Any help would be great, I don't mind traveling a little bit for good work. Thanks, jake

I'm in the same boat, they said turn the pressure shutoff down, not sure how many times I can turn it but now its leaking so looks like I need to call and get the upgraded one?

Re: Electirc Rear Jack Problem Bill, Yes that is the plan but if I can fix it I would like to do that. I just moved to your area, who do you recommend for warranty work? I took it in for some small stuff and after a month of them having it they hadn't even contacted heartland. I called...

Re: Electirc Rear Jack Problem Just experienced this with my 3010 yesterday, didn't have time to tear into it but will this week. its less than a year old and I'm not happy about it!!!

They sent me the whole assembly, just had to take a few measurements to make sure I got the right one.

This is an old thread but I just did mine on my 2011 3010 and dexter was great to deal with, they even offered to pay me to do it as if I took it somewhere. since I do live on an island in Alaska we don't exactly have a dealer near. Great customer service, and it only took 30 mins to do.

Thanks Porthole, here are the wheels on my Cyclone (8 spoke). I will look into what the actual psi rating is for the wheels, or if anyone knows off hand that would be great too.

Been looking at the G614's also, but just curious what the wheels on my 2011 3010 cyclone are rated for?

Porthole- Thanks will take a look, do you know if there is any breaker or fuse on the transfer box? I'm hoping it was a freak thing just from being so cold. I started it 2 weeks ago and had no problems at all. Also where can I find a good wiring diagram for my 3010? I tried in the wiki, but no...

Wingfoot- The breakers never actually tripped, but I turned them off then back on. At no time was there a load on the Gen Set. Normally when I start it, I watch for the TV light to come on and microwave to beep, kinda my tell tell sign the AC power is now on, and then allow it to warm up a...

porthole- Yes checked those, and reset multiple times. I am not using shore power, I was trying to run my Genset to power my heat gun to remove a decal, but after I started it, it never kicked on the AC power. I will be getting back in there tomorrow or Sunday and look around some more. Jake

JohnDar- Thats what I was thinking just not sure where to find it. I looked around but didn't have my batt drill to take off the wall in the basement, so that will be a job for tomorrow. Branson4020- I did not see any breakers, the 4x4 I think you talking about when i opened it up was just a...

I went out to run the generator today, started just fine. Waited a few minutes like normal for the AC power to kick on, and nothing. Checked all the breakers and fuses, in the trailer and at the Generator, ran it for almost 20 mins with nothing. Is there something I'm missing? It is 8* outside...

Riddler6.7, I just sold my 07 sb, I had no issues with out the slider pulling my 3010. The new 11.5 I will be recieveing this week will have the companion in it, and it is also a sb w/o a slider. Hope that