Recent content by blong

Folks, Just a heads up to check your correct track nuts for tightness, These are the bolts the go through the yellow plates into the frame shackles that hold the suspension up on your trailer. We picked up our rig August last year. Its been for two outings one brief week long run last summer...

Had the same problem.... ensure the screws that hold the bracket to the trailer are all the way in I had to tighten ours and then the bracket clipped in and out just fine.

Ours came with all 4 plastic insert panels about 2 inches too short ,made a warranty claim and the new one they sent are about 4 inches too short so will be calling them back next week so yes they are probably all too short.

Hi Jae You have a few options that have read about here and tried. 1)metal Stud finder - personally used successfully to mount a tv hold on the wall of a 3950 2)call heartland to get schematic of the wall in question - Tried without as much luck, hard to read and they sent a generic diagram of...

Got ours from tweetys , they had the best price at the time.

I was told by long time friend and truck mechanic no need for the dual alternators unless you have a lot of aftermarket accessories that run all the time and you idle a lot, so we opted out and went with single, have had no issues. You will love the new Denali, picked ours up in December, its...

We ordered for ours, its okay and matches and we got it as part of the deal, but if you have the three season wall for your back patio like we do, its actually too long and has to be rolled up or cut I guess, PITA, not really worth it and wont bother on our next rig.

We got them on our previous rig because they were there, and this year it was a deal breaker on the new one, so we ordered instead of buying without off the lot. Never will have another trailer without, worth every penny and no sweating between panes... and we travel south in the spring, even...

You will love that truck, towing anything with DRW is so much more stable. I drive mine daily with no issues. The cameras and parking sensors make parking alot easier than you would think. Not sure what year your 2500 was, but i just upgraded went from a 2011 to a new 2015 and and the upgrades...

Rims are part of it, need to upgrade your valve stems too as they are also different for the 110 rating, they must be all metal, not half and half like with the 80 lbs rating.

We have gone done for March break 10 days for the last two years, and are going back again this year. We have a 15 year old and she loves it. Park is clean and well kept, spots are cleaned and straightened up after each camper leaves by a Disney crew of folks, some a little tight for our 45 fvr...

Re The Licence questions and weigh scale comments, let me clarify as checked with the DOT when we got ours a few years back. In Ontario, if you are driving any rig with a 5th wheel camping trailer over 23,000 lbs combined weight (truck and trailer), YES, you need an AR (R=Restricted) licence...

A vote For Firestone, I was going to install air lift bags but you have to drill on GM trucks if you have an in-bed 5ver or gooseneck hitch (duh), so I sent them back and installed the firestone, no drilling required. I had them my 2011 for 3 years with no issues, traded it in and just added...

Thanks Murry, I could do that too, my tool box sits in the bed so its under the tonneau but I could mount it on the side of it. How do you like the air lift wireless air system, have read a few mixed reviews.

Hey Folks, Just curious where folks have chosen to mount their compressors for their on board air bag control. Both Air Lift, and Firestone, want "protected" from weather locations and no heat, so to me that only leaves inside the cab. My previous truck, I mounted it up under the bed on the...