I can't figure out how to adjust the independent zones for A,B & C volume(s). I tried the setup menu, but my Genesis doesn't show Front, Center, Rear. My only 2 choices are Audio Out and Key. Is there something I'm missing...or is there a firmware upgrade?
You were right! We do burn an occasional candle...and cooking smoke perhaps. Used a mild detergent, and it cleaned up fine...it's just intersting that it outlined the framing members. thanks for the advice!
I've noticed for some time that certain times of the day, I can see faint darker lines on the ceiling. They almost look like shadows. They follow the lines of the aluminum rafters. Also, I see it on some of the interior walls as well. Is this normal?
I was thinking that the roller shade would have about an inch air gap between the window and the shade, but the shade is partially transparent, so some sun will be filtered in to the window. However, with the awning, some of the sun may strike the window directly depending on the angle of the...
I'm considering installing a couple of Window Awnings on my FW, but after looking at the www.carefreeofcolorado.com website, I see that they have a roller-style window shade as well. It's recommended for the rear window, but I don't know why it couldn't be used on any window. Can anyone...
I haven't had the opportunity to tell how well the antenna performed. Since we bought the RV, we've mostly had cable. When we leave this area, I'll keep an eye on it to see how we're doing compared to the 'neighbors'. The head unit looks fairly simple to remove and replace, if...
After working with AntennaTek, they agreed to send me a gear kit. It seems that the plastic gear (attached to the shaft) was broken below the o-ring...I didn't even know there was an o-ring, until I forced the shaft out...then the o-ring came out as well, but the rest of the plastic is stuck...
I have a 2014 Gateway with an AntennaTek Antenna. I'm not sure which model. I think it may be Model #500. It rotates fine, but doesn't crank up or down. I removed the plastic plug on top...and the handle from the inside. Also removed the pins holding the antenna. Then, I removed the worm...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.