My shower hose is also difficult to remove at times. Make certain that no pressure remains in the hose, spray with WD 40 and work hose in and out at connector as explained above has always got it released.
I can feel your pain. Our LM San Antonio sits all summer connected to a utility that provides online access to our daily kwh usage. We have the large RV type refrigerator and operate it and the water heater on electric. When the trailer is non occupied with refrigerator and converter operating...
Ashland UDC
Your receptacle should be GFCI protected and have a weatherproof cover. Switches do not offer GFCI protection unless provided at the breaker.
Goof Off is also the product to use to remove the roadway lane marking paint sprayed up on your vehicle’s fenders if you are unfortunate enough to encounter roadway lane marking. It removes the paint without damaging the automotive finish. It also will work on your RV as well but you will need...
It looks like your new anode may be longer than old. It may be hitting back of tank. You can adjust with hacksaw if needed.
Sent from my iPhone using Tapatalk
Take a 3/4” steel pipe coupling and try fitting it onto the new anode. That will tell you if you have an incorrectly threaded anode.
Sent from my iPhone using Tapatalk
Etrailer carries several colors and widths. Be careful not to stretch the vinyl when you install it or it will shrink back.
Sent from my iPhone using Tapatalk
I think we all realize that our trailers see frame flex as they are towed, turned, and cross uneven pavement. The fiberglass cracks at the corners of slide openings probably are cosmetic and would not represent a frame failure. The bulge in my estimation would indicate frame stress but not...
I have a 2015 LM San Antonio that was built early model year before the 365’s came out. I have the same curb side bulge as you indicate. I know there is frame structure behind the bulge because you can “read” the framework through the fiberglass when the dew is just right. The bulge is at the...
The bottom cord of that truss has definitely had a lateral shift at some point as all the rods in the same direction are broken. If the frame members appear to be straight I would grind/trim the ends of the rods until you can get them to align again. It appears difficult to get back to the top...
Unlike all other fifth wheel hitches, auto slide hitches are mechanically driven by the hitch head turning with the pin box. This is achieved by an adapter that is required to be used with the hitch. The adapter has a wedge that slides into the pin slot on the head to keep the pin from turning...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.