Recent content by Jacknel

I designed brackets out of aluminum. Clamp brackets (fit loose) over ends of awning roller. Buy 2 - 10' lengths of 3/4" threaded pipe and screw one end into the bracket. Cut the other end 2" above the ground, drill a 5/16" hole 1" from end and bolt to feet. Either lag feed to patio or if on...

I am looking for supports to attach from the ground to my awning roller to protect in high winds.

I had mine done at the rally and couldn't be happier. It was a wash and wax that they offered me, not a new trailer. They gave my RV a good wash and wax.

We have a 2013 Big Country 3450TS. While at the Goshen rally I bought a couple of struts for the large cargo door. They gave me 80# struts at the parts and service area. I glued 2 pieces of 3/16 aluminum to the interior of the door to attach the struts to but when I go to close the door the...

I contacted Heartland and it is located to the left of mirrored closet doors. It Is located above the Small shelf. I drilled a 1" hole from inside the closet first to make sure the wire was there and then drilled from bedroom side. Everything looks and works great.

I have a 2013 Big Country 3450ts and need a location to mount A/C thermostat to connect to existing wire

This is how I connected a Honeywell programable thermostat to my furnace. Since I only wanted to program my heating and not my cooling, I disconnected the two thermostat wires from my AC to my furnace. I simply cut the two blue wires near the furnace, and put a marr connecter on each AC wire to...

If you use a programable to run the furnace only, use a thermostat with batteries and connect to the thermostat wires on the furnace. All you are doing is closing a switch on the thermostat to run the furnace. Voltage doesn't matter when you wire this way. Let me know if you need detailed...

I didn't take any pictures, but if there is anything I can clarify I would be happy to answer any questions. I will also be at the Goshen rally.

I have a digital Dometic thermostat and a Dometic AC with a Suburban furnace. I wanted to program the furnace so I could sleep cool and wake up warm, but Dometic said it couldn't be done. Since I didn't want to program the cooling, I left the Dometic connected to the AC but disconnected the blue...

My Big Country also has a removable panel in the shower stall. The check valve was installed backwards. Flush works great now.

My thermostat is exactly like the one shown. There are three wires connected. 12+12-comms. I would like to replace with a Honeywell programable, but need wiring instructions. Anyone out there that can help? Thanks

Is there going to be a 4 step available for me? Also, I am having a 6 point level system installed on Monday 15th. They may want to install steps at the same time.

I have a folding tonneau cover on my crew cab truck and can't see the hitch when backing up. I used to remove the tonneau cover to hook up, but got a brain wave. I attach a magnetic pick up tool to the front of 5th wheel plate and extend the tool enough to see it over the tonneau cover. It has...

I have used a construction adhesive for this, but a word of caution. Do not change your mind and try to remove, but a lot stronger than screws in a thin wall.