Recent content by jtcfishing

Hello done it again I did a lot of shopping and picked the curt hitch very well made at a good price have had no problems with it and would recomend it. I had a reese hitch before this one and the 20k curt is a much better hitch.

Dave012 I also put firestone airbags on my truck and like you I also needed air for tires and toys and a trail-air hitch so I purchesed a firestone high pressure 12v air compresser it does a really good job even on 110lbs.for the trailer and truck tires. The best part is it is so portable,came...

The low point drains on our landmark were really long so I cut them off as short as possable and put one of the plastic insulated focet covers on it and have not had any problems with freezing,also removed the access door to plumbing in basement and run a ceramic heater at 55 deg. setting for...

cjwigley you may check your dryer vent hose mine did not fit the fittings very well and I had a lot of dust from that. Tighten the hose clamps then rapped with duct tape ,no more dust!!

Hi everyone it is about -4 herrreee in kc mo,just a little snow but lots of wind about 25 to 30.That is a wonderful photo!

Thanks for the link westxsrt10!

If you dont mind could you send me or post where you purchaced the hose look like something I would be in the market for. Thanks John

Hello Campdually my name is John Carathers I have a 09 Landmark and have a concern that the springs and axles are some of the batch that are causing trouble! I would like to ask who you used as the contact at lippert frames ? We are fulltiming in Kansas City so taking it in is out I am going...

Hello Mr.Osborne my name is John Carthers we have a 09 Landmark we are fulltiming in kanas city Mo. I have looked at our springs and have a concern that they are some of the ones that have given trouble. I was going to ask if you could tell me your contact at lippret frames I am going to try...

Hello Mark I hope you can help I looked at our springs and have concerns that we are going to have trouble with breakage,they are flat! If you could would you tell me the contact you used at lipert frames any help would be great,we are fulltiming so taking it in is out will try just to get...

Hello Gary we have a 09 Landmark with the trial air hitch, the first time I pulled mine it was set at around 50 psi. After pulling ours a few hundred miles I found that about 75 to 85 psi was better for my ride. The way you load your coach will make the tounge or hitch weight change. The dips...

Hello Randy&Kathy we use a piece of memory foam rolled up put in the hole then allowed to expand.The foam will you run your hose and sat. wires in then seal up around them has worked great for us even in below 0 weather.The piece I use is about 8x16 it really gets tight when it expands,hope this...

Patrick Hello,We have been fulltiming since Oct. I just installed some of the jt style stabilers and let me say they are great. A week after, I purchased some of the screw up stands you are talking about to put on the frame in front of the wheels.It is a long span from front to rear jacks so I...

Patrick, first Hello we also use the blocks in the rear to shorten the space,only use a single on the front on soft gravel.I have been fulltiming starting in Oct. and just put on a set of the jt or bal type stabilers on our coach what a differance they make!! If you are concerned about movement...

That is a really good question I have seen the same and never asked.Please somebody has the answer.