Re: Dimond Plate
Sorry it took so long to say thanks for the info. Sounds good to me. I was still expecting a reply from the factory since this is the ask the facctory site. Once again thanks for you reply. Marty in Denver
I need to put some Diamond Plate on the front of my 21FBS, Could you send me a picture or blueprint of the front under the front cover. Have a "v" hole in on the bottom in the middle. Thanks Marty
Spent a 3 week streach in our 21Fbs and had no problem with food prep. Used both sinks and if we needed more room we used part of the table. There was just the wife and myself. When I cook I try to use as little room as possible. I make the mess, the wife cleans up. Marty
True the ficia is heldon by screws but it is also stapled to the top. once you get the screws out you need to pry the ficia away from the front. Its almost a two person job. One to pry and one to hold it up. Onice I got it off I cut the staples and the screws hold it up just fine. Marty in...
I asked this else where but I'll ask here also. Checking sink fittings to make sure everything was tight I found that there is nothing connected to my hot water connection of bathroom sink. Did someone fall down on the job or what? Marty
Moderator Note:
Longshot1, I'd say if you have a...
Hi Jonille. Have the installation guide right here. the oven is an Apollo and the cut out for the oven is 23 3/4 wide 16 5/8 high and 19 1/4 deep. They don't giv the inside demention on this paperwork. Hope this helps. And yess the battery does move the extention ..I was asking about...
Extertion
Thank you for doing that. I understand people ar busy but afterbeein in the partsand customer service aera for over 20 years I would think tat it should never take 3 days to call someone back. If he was out of town why did the operator transfer me to his number. I'm not really...
Extertion
Iwish I could get a quick reply. I called on Wed., Thur., and Fri., Operator connected me to someone. The recording said I am on the phome or away from my desk, I'll returnyour call as soon as i can. So far no call.
With the 5 screws out the fascia just hung there. After finding out about the nails I started pulling. Well if finally came off. The pin nails they used were two inches long. Some of them came out of the fascia and stayed in the backstop, others stayed in the fascia. So I just cut them off...
Well I took the 5 screws out of the top fascia on my 21FBS. but was unable to remove it. I don't want to pull to hard but it doesn't seem to move . Then I called the dealer and they told me I had to buy this adapter my self. I told them I don't think so. So hes checking to find a part...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.